1859063 VALVE GP-CHECK Caterpillar parts
311B, 312B, 312B L, 315B, 315B FM L, 315B L, 317B LN, 318B
Rating:
Alternative (cross code) number:
CA1859063
185-9063
1859063
CA1859063
185-9063
1859063
Weight: 7 pounds 3 kg.
EXCAVATOR,
Compatible equipment models: 1859063:
Number on catalog scheme:
26
For full view, you need register
Information:
Loosen the vent plug (1) on top of fuel filter base (2).
Illustration 2 g00310703
(3) Fuel transfer pump
Operate the priming lever on the bottom of the fuel transfer pump (3) until fuel, which is free of air, flows from the vent plug. Tighten the vent plug. Note: If the drive cam of the fuel transfer pump is at maximum lift, the priming lever cannot be operated. The crankshaft must be rotated one revolution.
Illustration 3 g00310743
(4) Nut for the fuel line to the air inlet heater
If the fuel line for the air inlet heater has been drained, loosen the nut (4) for the fuel line at the air inlet heater. Operate the priming lever on the bottom of the fuel transfer pump (3) until fuel, which is free of air, flows from the fuel line. Tighten the nut for the fuel line to the air inlet heater to a torque of 22 N m (16 lb ft).
Illustration 4 g00310824
(5) Nuts for the fuel line to the fuel injection nozzles
Air from the fuel lines is also removed by loosening the nuts (5) for the fuel line at the fuel injection nozzles. Operate the starting motor until the fuel, which is free of air, flows from the fuel line. Tighten the nuts for the fuel lines (5) to a torque of 22 N m (16 lb ft).
Do not crank the engine for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking again.Turbocharger (if equipped) damage can result, if the engine rpm is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient.
Remove Air From The Fuel System On Type 2 Engines and 7BJ Engines
Note: For a complete description of Type 1 and Type 2 engines, refer to the Systems Operation, Testing and Adjusting Module, "Engine Design" for more information.If air enters the fuel system, the air must be purged before the engine can be started. Air can enter the system when the following events occur:
The fuel tank is empty or the tank has been partially drained.
The low pressure fuel lines are disconnected.
A leak exists in the low pressure fuel system.
The fuel filter is replaced.Use the following procedure in order to remove air from the fuel system:
Illustration 5 g00310885
Fuel filter and fuel filter base (Lucas Fuel Systems)
(1) Vent plug
(2) Fuel filter and fuel filter base
Illustration 6 g00310703
(3) Fuel transfer pump
Loosen the vent plug (1) on top of the fuel filter and filter bases. Operate the priming lever on the bottom of the fuel transfer pump (3) until fuel, which is free of air, flows from the vent plug. Tighten the vent plug.
Illustration 7 g00804995
Fuel filter and filter assemblies (Stanadyne Fuel System)
(1) Vent plug for the fuel filter (if equipped)
Stanadyne fuel system Loosen vent plug (1) on top of primary fuel
Caterpillar SIS machinery equipment:
Caterpillar SIS
312B & 312B L Excavators 2KW00001-UP (MACHINE) POWERED BY 3054 Engine »
185-9063
VALVE GP-CHECK
315B L Excavator 5SW00001-UP (MACHINE) POWERED BY 3054 Engine »
185-9063
VALVE GP-CHECK
318B L and 318B LN Excavators ADC00001-UP (MACHINE) POWERED BY 3046 Engine »
185-9063
VALVE GP-CHECK
317B L & 317B LN Excavators 6DZ00001-UP (MACHINE) POWERED BY 3046 Engine »
185-9063
VALVE GP-CHECK
318B L & 318B LN Excavators 3LR00001-UP (MACHINE) POWERED BY 3046 Engine »
185-9063
VALVE GP-CHECK
311B TRACK-TYPE EXCAVATORS 2LS00001-UP (MACHINE) POWERED BY 3064 ENGINE »
185-9063
CHECK VALVE GROUP
312B & 312B L TRACK-TYPE EXCAVATORS 2NS00001-UP (MACHINE) POWERED BY 3064 ENGINE »
185-9063
VALVE GP-CHECK
315B & 315B L TRACK-TYPE EXCAVATORS 1SW00001-UP (MACHINE) POWERED BY 3046 ENGINE »
185-9063
VALVE GP-CHECK
315B FOREST MACHINE 7RZ00001-UP (MACHINE) POWERED BY 3046 ENGINE »
185-9063
VALVE GP-CHECK
Caterpillar parts catalog:
Parts valve Caterpillar catalog:
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 307, 307B, 307C, 308C, 311B, 311C, 312, 312B, 312B L, 312C L, 312D, 313B, 315, 315B, 315B FM L, 315B L, 315C, 315D L, 317B LN, 318B, 318C, 319C, 319D,...
305.5, 306, 306E, 307B, 307C, 307D, 308C, 308D, 311, 311B, 311C, 311D LRR, 312B, 312B L, 312C, 312C L, 312D, 312D L, 313B, 314C, 314D CR, 314D LCR, 315, 315B, 315B L, 315C, 315D L, 317B LN, 318B, 318C...
315, 315B, 315C, 317B LN, 318B, 933, 933C, 939, 939C, D3C III, D3G, D4C III, D4G, D5C III, D5G
315, 315B, 315C, 317B LN, 318B, 933, 933C, 939, 939C, D3C III, D3G, D4C III, D4G, D5C III, D5G
311B, 312B, 312C, 312C L, 315C, 318B, 318C, 319C, 320B, 320C, 320C FM, 320C L, 322C, 325B, 325C, 330C, 330C L, 345B II, 350, 365B, 365B L, 375, 385B
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D LRR, 321B, 321C, 323D L, 323D LN
311, 311B, 311C, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D LRR, 320N, 321C, 323D L, 323D LN
311, 311B, 311C, 312B, 312C L, 320 L, 320B, 320C, 320C FM, 320N
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM RR, 320D LRR, 320D RR, 320N, 321C, 321D LCR, 323D L, 323D LN
311, 311B, 311C, 311D LRR, 312, 312B, 312C, 312C L, 312D, 312D L, 313D, 314C, 314D CR, 314D LCR, 315D L, 318C, 318D L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 3...
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320B U, 320C, 320C FM, 320C L, 320D, 320D LRR, 320N, 321C, 323D L, 323D LN
311B, 311C, 311D LRR, 312B, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 320C, 320C FM, 320C L, 320D FM RR, 320D LRR, 320D RR, 320E, 320E L, 320E LN...
1P8954
VALVE GP-SELECTOR & PRESS CONT
627E, 627F, 627G
627E, 627F, 627G
1225365
VALVE GP-CONTROL
311, 312
311, 312
6G8920
VALVE GP-AIR CONTROL
621E, 623E, 627E, 631E, 637E, 651E, 657E
621E, 623E, 627E, 631E, 637E, 651E, 657E
2436513
VALVE & MTG GP-MAIN CONTROL
HA771, HA871, TK371, TK381
HA771, HA871, TK371, TK381
6E5680
VALVE GP-BANK
910E
910E
2813157
VALVE GP-TRANSMISSION CONTROL
120H, 12H, 135H, 140H, 160H
120H, 12H, 135H, 140H, 160H
2074566
VALVE GP-CHECK & RELIEF
330B L, W330B
330B L, W330B
1057457
VALVE GP-RELIEF
311, 312
311, 312
2553591
VALVE GP-SEQUENCE
730, 730C
730, 730C