AVSPARE.COM
parts catalog

VALVE AS 1859064 - Caterpillar


1859064 VALVE AS Caterpillar parts 311B, 312B, 312B L, 315B L, 317B LN, 318B
Rating:
41
Alternative (cross code) number:
CA1859064
185-9064
1859064
Caterpillar 1859064 VALVE AS
Weight: 0.22 pounds 0 kg.

Buy VALVE AS 1859064 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 1859064:

EXCAVATOR  311B   312B   312B L   315B L   317B LN   318B   Caterpillar
Number on catalog scheme: 3
  For full view, you need register

Information:


Illustration 1 g02041273
Schematic of the rotor clutch solenoidThis diagnostic code is recorded when the Computerized Profiler Control ECM reads an above-normal current of the solenoid circuit for the rotor clutch.The possible causes of this diagnostic code are listed below:
The energizer circuit of the solenoid circuit is shorted to ground.
The solenoid has failed.
The ECM has failed (unlikely).Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes. Clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 754 FMI F06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:A Category 3 warning is shown on the Computerized Monitoring System (CMS) for the solenoid which affects the propulsion, steering, or rotor control.Test Step 1. CHECK THE SOLENOID
Turn the key start switch to the ON position.
Ensure that the diagnostic code CID 754 FMI F06 is active.
Observe the status of the CID 754 FMI F06.
Disconnect the machine harness from the solenoid and the ECM.Expected Result:The CID 754 FMI F06 changes to CID 754 FMI F05 when the solenoid is disconnected.Results:
OK - CID 754 FMI F06 changes to CID 754 FMI F05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the failure of the solenoid. Replace the solenoid.STOP
NOT OK - CID 754 FMI F06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZER CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND
Turn the key start switch to the OFF position.
Disconnect the machine harness from the solenoid.
Disconnect the machine harness connector from the ECM.
At the ECM machine harness connector, measure the resistance from the energizer circuit or signal contact 37 (wire L941-OR) to all possible sources of ground. The possible ground sources are contacts 2 and 39.Expected Result:Each resistance should be greater than 5000 ohms.Results:
OK - Each resistance is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance is not greater than 5000 ohms. There is a short in the machine harness. The short is between the wire for the energizer circuit or signal contact 37 (wire L941-OR) and the circuit with a low resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS
Inspect and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the key start switch to the ON position.
Enter diagnostic mode of the Computerized Profiler Control ECM and clear all inactive diagnostic codes.
Operate the machine.
Check the status of the CID 754 FMI F06.Expected Result:The CID 754 FMI F06 is active.Results:
OK - The CID 754 FMI F06 is active. The fault has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. Refer to the Electrical Schematic of the machine and check all involved wiring harness connectors and wiring. Ensure

Caterpillar parts catalog:

Caterpillar parts catalog
312B & 312B L Excavators 2KW00001-UP (MACHINE) POWERED BY 3054 Engine
315B L Excavator 5SW00001-UP (MACHINE) POWERED BY 3054 Engine
318B L and 318B LN Excavators ADC00001-UP (MACHINE) POWERED BY 3046 Engine
317B L & 317B LN Excavators 6DZ00001-UP (MACHINE) POWERED BY 3046 Engine
318B L & 318B LN Excavators 3LR00001-UP (MACHINE) POWERED BY 3046 Engine


Parts valve Caterpillar catalog:

0952927 VALVE-FILL
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 307, 307B, 307C, 308C, 311B, 311C, 312, 312B, 312B L, 312C L, 312D, 313B, 315, 315B, 315B FM L, 315B L, 315C, 315D L, 317B LN, 318B, 318C, 319C, 319D,...
1284411 VALVE AS
305.5, 306, 306E, 307B, 307C, 307D, 308C, 308D, 311, 311B, 311C, 311D LRR, 312B, 312B L, 312C, 312C L, 312D, 312D L, 313B, 314C, 314D CR, 314D LCR, 315, 315B, 315B L, 315C, 315D L, 317B LN, 318B, 318C...
1039269 VALVE-INLET
315, 315B, 315C, 317B LN, 318B, 933, 933C, 939, 939C, D3C III, D3G, D4C III, D4G, D5C III, D5G
1039270 VALVE-EXHAUST
315, 315B, 315C, 317B LN, 318B, 933, 933C, 939, 939C, D3C III, D3G, D4C III, D4G, D5C III, D5G
1300263 VALVE AS
311B, 312B, 312C, 312C L, 315C, 318B, 318C, 319C, 320B, 320C, 320C FM, 320C L, 322C, 325B, 325C, 330C, 330C L, 345B II, 350, 365B, 365B L, 375, 385B
5I7526 VALVE
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D LRR, 321B, 321C, 323D L, 323D LN
5I7739 VALVE
311, 311B, 311C, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D LRR, 320N, 321C, 323D L, 323D LN
5I7738 VALVE
311, 311B, 311C, 312B, 312C L, 320 L, 320B, 320C, 320C FM, 320N
5I8026 VALVE AS
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM RR, 320D LRR, 320D RR, 320N, 321C, 321D LCR, 323D L, 323D LN
5I8066 VALVE AS-RELIEF
311, 311B, 311C, 311D LRR, 312, 312B, 312C, 312C L, 312D, 312D L, 313D, 314C, 314D CR, 314D LCR, 315D L, 318C, 318D L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 3...
5I7643 VALVE
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320B U, 320C, 320C FM, 320C L, 320D, 320D LRR, 320N, 321C, 323D L, 323D LN
1318901 VALVE-DUST
311B, 311C, 311D LRR, 312B, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 320C, 320C FM, 320C L, 320D FM RR, 320D LRR, 320D RR, 320E, 320E L, 320E LN...
1232598 VALVE AS
311B, 312B, 312B L, 315B L, 317B LN, 318B, 320B U
1232467 VALVE GP-PILOT
311B, 312B L, 315B L, 317B LN, 318B, 320B, 320B L, 322B L, 322B LN, 325B, 325B L, 330B L, 345B, 345B II, 345B II MH, 345B L, M325B, W330B, W345B II
1769096 VALVE GP-DIVERTER
312B L, 312C, 315B L, 315C, 317B LN, 318B, 318C, 319C
1298034 VALVE AS-BYPASS
2384C, 2484C, 311B, 312B, 312B L, 315B L, 317B LN, 318B, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D2, 320D2 GC, 320D2 L, 321B, 322B L, 322B LN, 322C, 322C FM, 3...
1315772 VALVE GP-PILOT
311B, 312B, 312B L, 313B, 315B, 315B L, 317B LN, 318B
1315769 VALVE GP-SHUTTLE
311B, 312B, 312B L, 315B, 315B L, 317B LN, 318B
1315768 VALVE-LOAD CHECK
311B, 311C, 311D LRR, 311F LRR, 312B, 312B L, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313B, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B, 315B L...
1315773 VALVE GP-PILOT
311B, 312B, 312B L, 313B, 315B, 315B L, 317B LN, 318B
1315770 VALVE AS-SHUTTLE
311B, 312B, 312B L, 315B, 315B L, 317B LN, 318B
1315771 VALVE AS-PRIORITY
312B, 312B L, 315B, 315B L, 317B LN, 318B
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.