VALVE & MTG GP-IMPLEMENT CONT 1892337 - Caterpillar

Illustration 6 g03711886
Touch "Screed Left Sensor" (11) or "Screed Right Sensor" (12). Note: The following steps describe the procedure used to calibrate the paddle for the right screed sensor. The procedure for calibrating the paddle for the left screed sensor is similar.
Illustration 7 g03711888
Read the on-screen warnings (13), touch "OK" icon (14).
Illustration 8 g03711896
Touch "OK" icon (14) to begin calibration.
Illustration 9 g03711916
Follow setup instructions (15).
Illustration 10 g03711935
Shut off the engine. Press and hold push to start switch (16) for 3 seconds. An LED next to the push to start switch will flash when the engine is in shutdown mode. Note: The engine may run for several minutes when placed in the shutdown mode.
Illustration 11 g03711924
When setup instructions are met, touch "NEXT" icon (17).
Illustration 12 g03711944
Follow calibration instructions (18).
Illustration 13 g03714859
Lift right paddle (19) to a 45 degree angle in order to place the paddle sensor in the full OFF position.
Illustration 14 g03711954
Touch "NEXT" icon (17).
Illustration 15 g03711960
Follow calibration instructions (20).
Illustration 16 g03714882
Lower right paddle (19) to the straight down position in order to place the paddle sensor in the full ON position.
Illustration 17 g03711966
Touch "NEXT" icon (17).
Illustration 18 g03711970
The display should now read "Calibration Successful" (21). Touch "OK" icon (14).
Repeat Step 9 through Step 13 to calibrate the left screed sensor.
Illustration 19 g03711976
Touch home icon (22) to exit the calibration screen.
Illustration 20 g03711980
Move machine power switch (23) to the OFF position.