VALVE GP-SOLENOID & MANIFOLD 1986577 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     333-0759     Injector Sleeve Shaft     1    
B     5P-3931     Antiseize Thread Compound     1    
Thoroughly clean the bore in the cylinder for the electronic unit injector sleeve.
Illustration 1 g02643976
Illustration 2 g01850908
Install new O-ring seals (1) on electronic unit injector sleeve (2) . Apply clean engine oil on O-ring seals (1) . Apply a light coat of Tooling (B) to Area (X) and install.
Install Tooling (A) into electronic unit injector sleeve (2) . Hand tighten electronic unit injector sleeve (2) until electronic unit injector sleeve (2) is seated in the cylinder head. Tighten electronic unit injector sleeve (2) to a torque of 120 10 N m (89 7 lb ft).
Remove Tooling (A) from electronic unit injector sleeve (2) .
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".End By:
Install the rocker shaft and pushrods.
Install the electronic unit injector.