VALVE GP-VIBRATORY 1G8364 - Caterpillar

The transmission direction that is currently in use, F (Forward), N (Neutral) or R (Reverse), is displayed on the instrument panel.Transmission Speed Switches
Upshift Gear Speed Switch (2)- Push upshift gear speed switch (2) to shift the machine into the next highest gear. The upshift gear speed switch is located on the STIC control lever.1 - First Speed2 - Second Speed3 - Third Speed4 - Fourth Speed (If Equipped) Downshift Gear Speed Switch (3)- Push downshift gear speed switch (3) to shift the machine into the next lowest gear. The downshift gear speed switch is located on the STIC control lever.4 - Fourth Speed (If Equipped)3 - Third Speed2 - Second Speed1 - First Speed When the parking brake is engaged, the machine cannot be shifted into first gear speed (unless parking brake drive through is activated). Refer to the topic Parking Brake Controls in the Machine Controls section of this manual. The gear speed that is currently in use is displayed on the instrument panel.Autoshift
Manual Mode- The gear speed is selected by rotating Auto/Man switch (1) to manual position (2). When switch (1) is in the MANUAL position, the transmission gear speeds can be selected by pressing and releasing upshift switch (3) or downshift switch (4). Automatic Mode- Automatic up and down shifting is provided in gears at or below the highest speed setting on Auto/Man switch (1).The downshift switch (4) is active in all gears and causes transmission downshifts to occur at higher than normal machine speeds.Pressing and releasing downshift switch (4) will cause a one gear downshift, provided the machine and engine speeds are such that an engine overspeed would not occur.Pressing and holding downshift switch (4) will cause the transmission to continue to downshift as the machine speed decreases.The transmission will remain in the downshifted gear for three seconds after downshift switch (4) is released before automatic shifting is resumed.Turn Auto/Man switch (1) to a selected gear speed to activate the autoshift function. The transmission will shift from first through to the selected gear automatically. Highest gear is controlled by the position of the gear speed selected on Auto/Man switch (1).Steering Controls
Remove the steering frame lock pin and store in the unlocked position. The steering frame lock pin must be removed to steer the machine. See Before Starting the Engine for information.The directional steering of the machine is controlled by the STIC steering lever.When the STIC steering lever is moved to the right of center, the machine steers to the right. When the STIC steering lever is moved to the left of center, the machine steers