VALVE (Exhaust) 1P2629 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery Charger - Check
Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Fan Drive Bearing - Lubricate
Fan Motor - Lubricate
Fumes Disposal Filter Element - Replace
Generator - Dry
Generator Winding - Test
Generator Winding Insulation - Test
Methane Gas Detector
Space Heater - Test
Daily
Control Panel - Inspect/Test
Coolant Level - Check
Fumes Disposal Filter Differential Pressure - Check
Walk-Around Inspection
Every Week
Battery Electrolyte Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Generator - Inspect
Generator Bearing Temperature - Test/Record
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Stator Winding Temperature - Test
Voltage and Frequency - Check
Initial 250 Service Hours
Engine Valve Lash and Bridge - Check
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Fumes Disposal Filter - Drain
Every 1000 Service Hours
Valve Stem Projection - Measure/Record
Every Year
Aftercooler Condensation - Drain
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Crankcase Blowby - Test/Record
Crankcase Pressure - Measure
Crankshaft Vibration Damper - Inspect
Cylinder Pressure - Test/Record
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil - Change
Engine Oil Filter - Change
Engine Oil Sample - Obtain
Engine Performance - Test
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash and Bridge - Check
Exhaust Bypass - Inspect
Exhaust Piping - Check
Fuel Metering Valve - Check
Gas Pressure Regulator Condensation - Drain
Generator Bearing - Lubricate
Generator Set - Test
Generator Set Vibration - Inspect
Hoses and Clamps - Inspect/Replace
Ignition System Timing - Check/Adjust
Inlet Air System - Check
Radiator - Clean
Spark Plugs - Inspect/Replace
Starting Motor - Inspect
Stator Lead - Check
Varistor - Inspect
Water Pump - Inspect
Every 3 Years
Coolant (DEAC) - Change
Coolant Temperature Regulator - Replace
Rotating Rectifier - Check
Rotating Rectifier - Inspect/Test
Turbocharger - Inspect