AVSPARE.COM
parts catalog

VALVE GP-TRANSMISSION CONTROL 2002049 - Caterpillar


2002049 VALVE GP-TRANSMISSION CONTROL Caterpillar parts 938G II, IT38G II
Rating:
27
Alternative (cross code) number:
CA2002049
200-2049
2002049
Caterpillar 2002049 VALVE GP-TRANSMISSION CONTROL

Buy VALVE GP-TRANSMISSION CONTROL 2002049 Caterpillar genuine, new aftermarket tractor parts with delivery
INTEGRATED TOOLCARRIER, WHEEL LOADER,

Compatible equipment models: 2002049:

INTEGRATED TOOLCARRIER  IT38G II  
WHEEL LOADER  938G II   Caterpillar
Number on catalog scheme: 5
  For full view, you need register

Information:


Illustration 1 g02359180
Schematic of the left brake pedal position sensor
This diagnostic code is recorded when the ECM reads the signal voltage of the left brake pedal position sensor and the voltage is too low. The operating range for the output voltage of the sensor is approximately 0 DCV to 5.0 DCV.The output frequency of the position sensor is approximately 500 Hz. The value of the sensor duty cycle is approximately 50% in the depressed position. The duty cycle of the signal increases as the brake pedal is pressed. The value of the sensor duty cycle is approximately 85% in the pressed position. The duty cycle of the signal decreases as the brake pedal is moved from the pressed position to depressed. The possible causes of this diagnostic code are listed here:
The sensor has failed.
The signal circuit in the machine harness is shorted to ground.
The ECM has failed. The ECM failing is unlikely. Test Step 1. CHECK THE SENSOR.
Disconnect the machine harness from the sensor. Expected Result:The diagnostic code changes from CID 0737 FMI 04 to CID 0737 FMI 03.Results:
OK - The diagnostic code changed from CID 0737 FMI 04 to CID 0737 FMI 03. This indicates that the failure is no longer present. The sensor has failed. Repair: Replace the sensor.STOP
NOT OK - The diagnostic code remains. The failure remains present. The sensor is not causing the failure. Proceed to test step 2.Test Step 2. CHECK THE HARNESS.
The sensor remains disconnected from the machine harness.
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness connectors from the ECM.
At the machine harness connector for the sensor, measure the resistance between the signal contact C (wire G746-WH(White)) and frame ground. Expected Result:The resistance is greater than 5000 ohms. Results:
OK - The resistance is greater than 5000 ohms. The harness circuit resistance is correct. The ECM may have failed. Repair: It is unlikely that the ECM has failed. Exit this procedure, and perform this procedure again. If the failure is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". STOP
NOT OK - The resistance is less than 5000 ohms. The machine harness has failed. There is a short between frame ground and the signal circuit in the machine harness. Repair: Repair the machine harness or replace the machine harness. STOP

Caterpillar parts catalog:

Caterpillar parts catalog
IT38G II Integrated Toolcarrier CSX00001-UP (MACHINE) POWERED BY 3126B Engine
IT38G II Integrated Toolcarrier JAN00001-UP (MACHINE) POWERED BY 3126B Engine
215-6224 Protection Ar-Corrosion Custom Product Support Literature for the 938G Series II Wheel Loader PHN00001-UP (MACHINE)
938G II Wheel Loader PHN00001-UP (MACHINE) POWERED BY 3126B Engine
938G II Wheel Loader CRD00001-UP (MACHINE) POWERED BY 3126B Engine
938G II Wheel Loader RTB00001-UP (MACHINE) POWERED BY 3126B Engine


Parts valve Caterpillar catalog:

2391134 VALVE GP-ETHER STARTING
120K, 120K 2, 120M, 120M 2, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 140G, 140H, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 143H, 14H, 14M, 160H, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 163H, 16M, 2290...
1492610 VALVE GP-SOLENOID
120H, 120H ES, 120H NA, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, 163H NA, 16G, 16H, 16H NA...
2070697 VALVE GP-PUMP CONTROL
844H, 938G II, 938H, 950G II, 950H, 962G II, 962H, 966H, 972H, 980K, 980K HLG, 980M, 982M, 990H, IT38G II, IT38H, IT62G II, IT62H
2D2511 VALVE GP-TIRE
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 140M 3, 143H,...
1143469 VALVE GP-RELIEF
307, 307B, 312, 3126B, 312B L, 315, 315B L, 317, 317B LN, 318B, 320B, 322B LN, 325B L, 330B L, 345B, 345B II, 345B II MH, 345B L, 350, 365B, 365B II, 375, 446B, 5080, 554, 564, 570B, 574, 574B, 580B, ...
6V7238 VALVE-SHUTOFF
1090, 1190, 1190T, 120K, 120K 2, 120M, 120M 2, 1290T, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 1390, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 214B, 2...
1549023 VALVE-SAMPLING
1090, 1190, 1190T, 120H, 120K, 120K 2, 1290T, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 135H, 1390, 140G, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M 2, 160M 3, 160M 3 AWD, 16M, 236D, 242...
3K6905 VALVE-BREATHER
140G, 3126, 3126B, 3208, 3412, 3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B, 3516C, 3606, 3608, 3612, 3616, 5130, 5130B, 515, 518, 5230, 5230B, 525, 525B, 525C, 525D, 528, 528B, 530B, 533, 535B...
1457390 VALVE-INLET
120H, 120K, 12K, 12M, 135H, 140K, 140M, 160K, 3126, 3126B, 3126E, 322C, 322C FM, 324D, 324D L, 324D LN, 325C, 325C FM, 325D, 325D L, 328D LCR, 561N, 570B, 580B, 938G II, 950G II, 950H, 953C, 962G II, ...
1478211 VALVE-EXHAUST
120H, 120K, 120K 2, 12K, 12M, 135H, 140G, 140K, 140K 2, 140M, 160K, 3126, 3126B, 3126E, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D L, 325...
8T3613 VALVE AS-PRESSURE
3176B, 3176C, 3196, 3306C, 814F, 815F, 816F, 824G, 825G, 826G, 910G, 914G, 933, 933C, 938G, 938G II, 939, 939C, 950F II, 960F, 966F II, 980F, 980F II, 980G, 992D, 994, 994D, AD40, AD45, AE40, C-10, C-...
1582336 VALVE-GAS
120M, 120M 2, 12M, 12M 2, 12M 3, 12M 3 AWD, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 5110B, 5130B, 735, 740, 784C, 785C, 785D, 789C, 793C, 793D, 797, 914G, 924F, 9...
3403327 VALVE GP-CONTROL
M313D, M315D, M315D 2, M316D, M317D 2, M318D, M318D MH, M322D, M322D MH
8U1650 VALVE GP
206B, 212B, 214B, 224B
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.