VALVE GP-MAIN CONTROL 2090270 - Caterpillar

Illustration 1 g01343715
Connections of the 5 Volt Supply
The sensor supply is a power supply that is internal to the ECM. The sensor supply provides +5 DCV in order to operate the sensors.This diagnostic code will be recorded when the Transmission ECM reads the voltage for the circuit of the sensor supply as being below normal.The results of this diagnostic code are listed:
All of the associated sensors will also log diagnostic codes.The possible causes of the diagnostic code are listed:
+5 DCV (wire R997-OR(Orange)) is shorted to ground between the sensor and the ECM.
The ECM has failed. This is unlikely.Test Step 1. CHECK THE SENSOR.
Ensure that the diagnostic code of SPN 1079 FMI 4 is present. The diagnostic code should be active.
Observe the status of the diagnostic code. The diagnostic code is active or the diagnostic code is NOT active.
Disconnect the machine harness from the sensor. Expected Result:The diagnostic code is NO longer active.Results:
OK - The diagnostic code is NO longer active. The sensor has failed.Repair: Replace the sensor.STOP
NOT OK - The diagnostic code remains active. The sensor is NOT causing the diagnostic code. Proceed to Test Step 2.Test Step 2. CHECK FOR A SHORT TO GROUND.
The sensor remains disconnected from the machine harness.
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness from the ECM.
At the ECM, measure the resistance between the contact of the sensor supply voltage and frame ground. See the schematic for more detailed information about the voltage of the sensor power supply for the sensor that is being tested. Expected Result:The resistance is greater than 5000 ohms. Results:
OK - The resistance that is measured is greater than 5000 ohms. The harness circuit is correct. The ECM has failed.Repair: It is unlikely that the ECM has failed. Exit this procedure. Perform the diagnostic code procedure for SPN 1079 FMI 4 again. If the cause of the diagnostic code is NOT found, replace the ECM . See Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - The resistance that is measured is less than 5000 ohms. The machine harness has failed. There is a short between frame ground and the contact for the sensor supply voltage in the machine harness.Repair: Repair the machine harness or replace the machine harness.STOP