2219576 VALVE GP-SOLENOID Caterpillar parts
5130B, 5230B, 773E, 775E, 776D, 777D, 785, 785B, 785C, 785D, 789, 789B, 789C, 789D, 793D, 793F, 793F AC, 793F CMD, 793F OEM, 795F AC, 797F, 994, 994D, 994F, 994H
Rating:
Alternative (cross code) number:
CA2219576
221-9576
2219576
CA2219576
221-9576
2219576
Weight: 3 pounds 1 kg.
MINING EXCAVATOR, WHEEL LOADER,
Compatible equipment models: 2219576:
Number on catalog scheme:
22
For full view, you need register
Information:
Table 2
FMI 3 Troubleshooting
Troubleshooting Test Steps Values Results
1. Check The Harness For An Open
A. Turn the key start switch and the disconnect switch to the OFF position.
B. Disconnect the machine harness connector from the switch.
C. Disconnect the machine harness connectors from the ECM.
D. At the harness connector for the switch, place a jumper wire between the normally open (N/O) contact and the normally closed (N/C) contact.
E. At machine harness connector for ECM, measure the resistance between the normally open (N/O) contact and the normally closed (N/C) contact.
The resistance is less than 5 Ω. OK - The resistance is less than 5 Ω. The (N/O) and (N/C) circuits are not open in the machine harness.
Proceed to Test Step 2.
NOT OK - The resistance reading for the (N/O) and (N/C) circuits greater than 5K Ω. There is an open in one of the circuits.
Note: A resistance that is greater than 5 Ω but less than 5K Ω would indicate a loose connection or a corroded connection in the circuit. A resistance measurement that is greater than 5K Ω would indicate an open in the circuit.
Repair: Repair or replace the machine harness.
Proceed to Test Step 5.
2. Check The Circuit For A Short
A. The harness connectors for the switch and ECM remain disconnected.
B. Remove the jumper wire that was installed in the previous test step.
C. At the ECM machine harness connector, measure the resistance between the (N/O) contact and all the other contacts used in the ECM.
D. At the ECM machine harness connector, measure the resistance between the (N/C) contact and all the other contacts used in the ECM.
The resistance measurements are greater than 5K Ω. OK - The resistance measurements are greater than 5K Ω.
Proceed to Test Step 3.
NOT OK - The resistance is less than 5K Ω. There is a short between the signal circuit and the circuit with the low-resistance measurement.
Note: A resistance that is greater than 5 Ω but less than 5K Ω would indicate a loose connection or a corroded connection in the circuit. A resistance measurement that is greater than 5K Ω would indicate an open in the circuit.
Repair: Repair or replace the machine harness.
Proceed to Test Step 5.
3. Check The Switch Ground Circuit
A. The key start switch and disconnect switch remain in the OFF position.
B. The
Cat SIS web machinery list:
Parts valve Caterpillar catalog:
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 511, 5130B, 521, 522, 5230, 5230B, 532, 541, 551, 552, 657G, 824G II, 824H, 825G II, 825H, 826G II, 826H, 938H, 950H, 962H, 966G, 966G II,...
120G, 120H, 12G, 12H, 12H NA, 130G, 135H, 140G, 140H, 140H NA, 143H, 14G, 14H, 14H NA, 160G, 160H, 163H, 16G, 16H, 16H NA, 5110B, 518, 5230, 5230B, 528, 621B, 631C, 633C, 639D, 666, 769, 769C, 769D, 7...
785C, 785D, 789C, 789D, 793B, 793C, 793D, 793F, 793F AC, 793F CMD, 793F OEM, 793F-XQ, 844, 844H, 854G, 854K, 990 II, 990H, 992C, 992D, 992G, 992K, 993K, 994, 994D, 994F, 994H
5130, 5130B, 5230, 5230B, 773D, 776C, 776D, 777B, 777D, 784B, 784C, 785, 785B, 785C, 785D, 789, 789B, 789C, 793, 793B, 793C, 793D, 797, 797B, 994, 994D, PR-1000, PR-750B
69D, 769D, 770, 771D, 772, 773D, 773E, 773F, 775D, 775E, 775F, 776C, 777D, 777F, 784B, 784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 793F, 793F AC, 793F CMD, 793F OEM, 793F-XQ, 795F AC, ...
768C, 769C, 769D, 771C, 771D, 772B, 773B, 773D, 773E, 775B, 775D, 775E, 776, 776C, 776D, 777, 777B, 777D, 784B, 784C, 785, 785B, 785C, 785D, 789, 789B, 789C, 789D, 793B, 793C, 793D, 797
768C, 769C, 769D, 771C, 771D, 772B, 773B, 773D, 775B, 775D, 776, 776C, 776D, 777, 777B, 777D, 785C, 789C, 793C
784B, 784C, 785B, 785C, 785D
772, 772B, 773B, 773D, 773E, 775B, 775D, 775E
772, 772B, 773, 773B, 773D, 773E, 773F, 773G, 773G LRC, 773G OEM, 775B, 775D, 775E, 775F, 775G, 775G LRC, 775G OEM
773B, 773D, 773E
769D, 771D, 773D, 773E, 775D, 775E, 776D, 777D
1223359
VALVE GP-CHECK
994, 994D, 994F, 994H
994, 994D, 994F, 994H
8E1415
VALVE AS-SHUTTLE
5230, 5230B, 777B, 785, 789, 793, 994, D11N
5230, 5230B, 777B, 785, 789, 793, 994, D11N
5110B, 5130, 5130B, 518, 5230, 5230B, 528, 784B, 784C, 785, 785B, 785C, 785D, 789B, 789C, 789D, 793F, 793F CMD, 793F OEM, 795F AC, 797F, 994, 994D, 994F, 994H
784C, 785C, 785D, 789C, 789D, 793, 793B, 793C, 793D, 797F, 994, 994D, 994F, 994H
5130B, 5230, 772, 773, 773D, 776C, 776D, 777, 777B, 777D, 784B, 784C, 785, 785B, 785C, 785D, 789, 789B, 789C, 793, 793B, 793C, 793D, 797B, 994, 994D, PR-1000, PR-450C, PR-750B
5130, 5130B, 5230, 5230B, 773D, 776C, 776D, 777B, 777D, 784B, 784C, 785, 785B, 785C, 785D, 789, 789B, 789C, 793, 793B, 793C, 793D, 797, 797B, 994, 994D, PR-1000, PR-750B
6E0878
VALVE
994
994
6E0859
VALVE GP-RELIEF
994, 994D, 994F, 994H
994, 994D, 994F, 994H
9T1614
VALVE
320C, 320D, 320D FM, 320D L, 320D LN, 320D LRR, 320D RR, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321D LCR, 322C, 323D L, 323D LN, 323D SA, 323E L, 324D, 324D FM, 324D L, 324D LN, 324E L, 32...
320C, 320D, 320D FM, 320D L, 320D LN, 320D LRR, 320D RR, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321D LCR, 322C, 323D L, 323D LN, 323D SA, 323E L, 324D, 324D FM, 324D L, 324D LN, 324E L, 32...
6E1268
VALVE GP
994
994
6E0873
VALVE GP
994
994
6E0871
VALVE GP
994
994