VALVE GP-RELIEF 2222629 - Caterpillar

Illustration 6 g02176761Engine Coolant Drain (4)This message is located on the right side of the machine.
Illustration 7 g01710035This machine is equipped with a remote coolant drain. The engine coolant can be drained from this location.Cat Extended Life Coolant (ELC) (5)This message is located on the underside of the radiator cap access cover on top of the engine compartment.
Illustration 8 g01132922Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" and Operation and Maintenance Manual, "Cooling System Coolant Extender (ELC) - Add" for more information.Refer to Operation and Maintenance Manual, "Fuel System - Fill" for more information.Do Not Weld and Do Not Drill (6)This message is located on the left-hand side of the front frame.
Illustration 9 g01175166Do not weld or drill the frame. Refer to Operation and Maintenance Manual, "Guards (Operator Protection)" for more information.Diesel Fuel Recommendations (7)This message is located next to fuel fill.
Illustration 10 g02157153
NACD Film
Illustration 11 g02052934
EAME Film
Use Ultralow Sulfur Diesel (ULSD) fuel.The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines certified to nonroad Tier 4 standards (Stage IV in Europe) and are equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability and will damage emissions control systems and/or shorten the service interval. Failures that result form the use of fuels are not Cat factory defects. Therefore the cost of repairs would not be covered by a Cat warranty.In Europe, ultra low sulfur diesel fuel will have a maximum of 0.0010 percent (10 ppm(mg/kg)) sulfur and is typically referred to as “sulfur-free”. This sulfur level is defined in European Standard "EN 590:2004".Refer to Special Publication, SEBU6250, "Caterpillar Machine Fluids Recommendations" for more information about diesel fuels and sulfur.Refer to Operation and Maintenance Manual, "Capacities (Refill)".Alternate Exit (8)If your machine is equipped with a snow wing, this message is located on the left ROPS support at the rear of the operator compartment.
Illustration 12 g00907967If the primary exits are blocked, use the hammer to break the window. Exit the machine through the window.Hydraulic System Oil (9)This message is located near the hydraulic tank filler cap. A grease pen may be used on the left-hand side of this film to write down the current hydraulic oil viscosity.
Illustration 13 g0163700624 V (10)This message is located near the auxiliary start receptacle. The machine is equipped with a dedicated 24 V electrical connection.
Illustration 14 g01183244Articulation Bearing (11)This message is located on the front left side of the top hitch assembly near the grease points for the articulation bearing.
Illustration 15 g01261194Engine Oil Drain (12)This message is located at the left rear of the machine near the drain valve for the engine oil.
Illustration 16 g01161760Hydraulic Tank Drain (13)This message is located at the left rear of the machine near the drain valve for the hydraulic system.
Illustration 17 g01261324