VALVE-GAS 2245152 - Caterpillar

The Caterpillar Monitoring System
Illustration 1 g00296905
Caterpillar Monitoring System Display Components for 583T & 587T. (1) Quad gauge electronic module. (2) Speedometer/tachometer electronic module. (3) Main display module. (4) Alert indicators. (5) Gauges. (6) Tachometer. (7) Ground speed readout. (8) Transmission gear readout. (9) Display area.
Illustration 2 g00741086
Caterpillar Monitoring System Display Components for 572R Series II. (1) Quad gauge module. (2) Lamp/Gear module. (3) Alert indicators. (4) Main display module. (5) Alert indicators. (6) Gauges. (7) Mode indicators. (8) Tach/Gear display. (9) Display area.
Illustration 3 g00898187
4C-8195 Control Service Tool (10) MODE switch (11) CLEAR switch (12) SCROLL switchThe main display module of the Caterpillar Monitoring System is used to show information. A mode select switch is provided on the dash panel. Momentarily pushing the switch will allow the operator to scroll through the numeric readout modes that are listed below:
Ground speed
Digital tachometer
Cumulative odometer
Service hour meter
Diagnostic codes Note: The unit indicators are automatically turned ON or OFF in order to correspond with the information that is shown on the numeric display. The values for the "odometer" may be displayed in either English units or metric units. Toggling between English and metric units can be performed with the control service tool or the ET. Diagnostic codes
The operator mode switch may be used to view the active diagnostic codes and the logged diagnostic codes. The serv code indicator will be illuminated while active fault codes are displayed. The serv code indicator will be OFF while logged diagnostic codes are displayed. Diagnostic codes can also be displayed through use of the 4C-8195 Control Service Tool or the ET. Clearing any diagnostic codes will require use of one of these service tools. The Caterpillar Electronic Technician (ET)
Illustration 4 g00777826
The Caterpillar Electronic Technician (ET) is a software program that is used to access data. The service technician will use the ET in order to perform the maintenance on the machine. Some of the options that are available with the Caterpillar Electronic Technician are listed below:
Diagnosis of problems
Viewing diagnostic codes
Viewing active event codes and logged event codes
View the status of parameters.
Clear active diagnostic codes and clear logged diagnostic codes
Perform calibration of machine systems.
Program the ECM (Flash). This is done with the "WINflash" program. See Troubleshooting, "Electronic Control Module (ECM) - Flash Program".
Print reports.See Troubleshooting, "Using Caterpillar Electronic Technician to Determine Diagnostic Codes". Diagnostic information is accessed with the following drop down menus:
Active diagnostic codes
Logged diagnostic codesLogged Event Codes
Illustration 5 g00859762
Logged events are provided with an indicator which is used to keep track of recurring or intermittent events. The data for the logged event shall include the following items: an event identifier (EID), a text description of the event, the number of occurrences of the event, a time stamp that shows the time that the event first occurred and a time stamp that shows the time that the event has most recently occurred .