VALVE GP-CONTROL 2271206 - Caterpillar

Table 1
Approximate Refill Capacities
Component or System Liters US gal Recommended Type
Fuel Tank 625 165 Refer to Operation and Maintenance Manual, "Lubricant Viscosities".
Cooling System 76.8 20.3
Engine Crankcase and Filter(1) 43 11.3
DEF Tank 24.0 6.3
Final Drive (each) 12.5 3.3
Hydraulic Tank Oil 75.0 19.8
Power Train Oil System and Filters 155 41
Pivot Shaft 40 10.6
Winch Sump (PA140VS) 15 4
Recoil Spring Compartment (each) 65 17.2
kg lbs
Refrigerant(2) 2.5 5.5 R-134a
mL oz
Refrigerant Oil (Compressor)(2) 180 6 Polyalkylene Glycol (PAG) Oil
Refrigerant Oil (Lines Group)(2) 226 7.64 Polyalkylene Glycol (PAG) Oil
(1) One Piece Oil Pan
(2) Refer to Service Manual, "Air Conditioning and Heating R-134a for All Caterpillar Machines" for additional informationNote: When you are operating on severe slopes (greater than 25 degrees or greater than 47 percent), the quantity of oil in the power train can be increased by as much as 10 percent. When you are operating with the increased oil quantity, prolonged operation in some machines can cause high-power train oil temperatures. After the work on the severe slopes has been completed, drain the excessive oil quantity from the bevel gear case.Note: For severe slope operation, engine oil should be maintained on the full mark. Never overfill the engine with oil.Ecology Drains
Table 2
Ecology Drain (Components)
Location (Drain) Needed Component
Coolant None
Transmission (If Equipped) 12.7 mm (0.5 inch)
pipe with 1/2-14 NPTH thread
Torque Converter (If Equipped) 12.7 mm (0.5 inch)
pipe with 1/2-14 NPTH thread
Engine Oil 25.4 mm (1 inch) pipe with 1-11 1/2 NPTH thread
Hydraulic Tank 126-7914 Oil Drain Coupling
or
25.4 mm (1 inch) pipe with 1-11 1/2 NPTH thread
Bevel Gear Case 4C-8563 Oil Drain Coupling
or
25.4 mm (1 inch) pipe with 1-11 1/2 NPTH thread