VALVE GP-RELIEF 2323374 - Caterpillar

Illustration 1 g06270279
Top view
Table 1
Specification for 227-6147 Swing Gear and Bearing Gp
Item Qty Part Specification Description
Note : Position "S" that is on inner race (9) relative to the carbody assembly (1) and bearing stopper (2). Refer to Illustration 1.
- - - The five holes which are marked (4) are not for use.
3 1 096-4902 Dowel Before assembly, apply Loctite C5A Copper anti-seize to dowel holes.
5 1 7Y-1650 Hose Clamp Torque to 5.39 0.49 N m (47.71 4.34 lb in).
6 8 8T-4136 Bolt Before assembly, apply blue Loctite 243 to the threads of bolts.
Torque to 37 4 N m (27 3 lb ft).
7 1 - Before assembly, apply 8C-8422 Sealant between mating surfaces of gear group and upper frame assembly and between carbody assembly and gear group.
8 4 455-3798 Bolt Before assembly, apply blue Loctite 243 to the threads of bolts.
Torque to 20 2 N m (177 18 lb in).
10 37 461-3880 Bolt Before assembly, remove compound, oil and dust from female threads, then apply Loctite C5A Copper anti-seize compound to the threads.
Use the following tightening procedure:
1. Tighten bolts to 150 15 N m (111 11 lb ft).
2. Turn to an additional angle of 70 5 degrees.
11 40 461-3879 Bolt Before assembly, remove compound, oil and dust from female threads, then apply Loctite C5A Copper anti-seize compound to the threads.
Use the following tightening procedure:
1. Tighten bolts to 150 15 N m (111 11 lb ft).
2. Turn to an additional angle of 60 5 degrees.
12 2 457-8759 Bolt Before assembly, apply blue Loctite 243 to the threads of bolts.
Torque to 20 2 N m (177 18 lb in).