VALVE AS-WATER 2380415 - Caterpillar

Remove retaining rings (15) and caps (16).Assembly Procedure
Table 3
Required Tools
Tool Part Number Part Description Qty
A 2H-4010 Bolt 1
2J-3507 Nut 1
5P-8250 Washer 1
1U-9895 Puller 1
FT-2450 Plate 1
Illustration 11 g06013929
Install caps (16) and retaining rings (15) .
Illustration 12 g06013919Note: Lubricate the seals lightly with the lubricant that is being sealed.
Install piston seals (13), O-ring seal (14), and dowels (12).
Illustration 13 g06013918
Install piston (11).
Illustration 14 g06013917
Typical example
Illustration 15 g06013916
Typical example
Illustration 16 g06013915
Typical example
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install guides (10) and springs (9).
Install Tooling (A). Use Tooling (A) to compress springs (9) and to lift guides (10).
Install horizontal pins (8) into guides (10).
Illustration 17 g06013914
Install retaining ring (7).
Illustration 18 g06013913
Install hub (6).
Illustration 19 g06013912
During assembly, dip five plates and four discs (4) with clean final drive oil.Note: Make sure that plates and discs are installed in an alternating order. Start with a plate and end with a plate.
Install five plates and four discs (5) in brake anchor (5).Installation Procedure
Table 4
Required Tools
Tool Part Number Part Description Qty
A 439-3940 Link Bracket 2
Illustration 20 g06013545
Typical example
Place service brake assembly on a suitable block.
Install Tooling (A) and a suitable lifting device to final drive assembly (1). The weight of final drive assembly (1) is approximately 740 kg (1631 lb). Install final drive assembly (1) on service brake assembly (3).
Install bolts (2).End by:Install Final Drive, Brake, Wheel, and Spindle.