VALVE GP- 2431699 - Caterpillar

"Machine Radio Configuration"
The "Machine Radio Configuration" menu allows you to change the number of the network or the frequency channel on data radios.To open the "Machine Radio Configuration" dialog, complete the following steps:
In service mode, select the "Installation" soft key from the "Setup" menu.
Illustration 1 g01301490
Press the arrow keys until "Machine Radio Configuration" is highlighted.
Press the "OK" key. The utility automatically attempts to connect to the radio.
Illustration 2 g01301489
Use the arrow keys (8) in order to select the same network as the base station for CR900 radios. Use the arrow keys (8) to select the same frequency as the base station for CR450 radios."Display's Radio Port"
When a third party radio is used, the display for the AccuGrade System allows the user to adjust the following communication parameters:
Baud Rate
ParityThe "Display's Radio Port" settings sets the speed at which the display communicates with the radio. These settings do not affect the speed of data transfer though the air between radios. Refer to the following Steps in order to adjust the "Display's Radio Port" settings.
Illustration 3 g01265962
(1) LCD (2) Soft Key Labels (3) Soft Keys (4) Escape Key (5 ) Next Key (6) Power Key (7) "+" Key (8) Arrow Keys (9) "-" Key (10) "OK" Key (11) Menu Key (12) Data Card Slot
To view all options in the "Setup Menu" dialog you must start the AccuGrade System in service mode.Note: Hold the "OK" key (10) and press the power key (6) in order to start the AccuGrade System in service mode.
Press the menu key (11) until the soft key label "Setup Menu" is shown. Press the soft key (3) beside the "Setup Menu" soft key label.
Select the soft key that is located beside the "Installation" soft key label from the "Setup" menu.
Illustration 4 g01288056
Press the arrow keys until "Display's Radio Port" is highlighted.
Illustration 5 g01288144
Press the "OK" key (10) .A screen that is similar to Illustration 5 will appear.
Press the arrow keys in order to adjust the "Baud Rate". Press the next key (5) in order to toggle between the fields in the "Display Radio Port".
Press the arrow keys in order to adjust the "Parity".
Press the "OK" key (10) .