VALVE GP-CONTROL 2441026 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02710382
Disconnect the plastic tube assembly from connection (2) on valve mechanism cover (1). Refer to Disassembly and Assembly, "Crankcase Breather - Remove" for the correct procedure.
Remove bolts (3) from valve mechanism cover (1).
Remove valve mechanism cover (1) from the cylinder head.
Illustration 2 g02710383
Remove seal (4) from valve mechanism cover (1). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g02710383
Thoroughly clean all gasket surface of valve mechanism cover (1). Clean the gasket surface of the cylinder head.
Thoroughly clean the seal recess in the valve mechanism cover (1).
Inspect seal (4) for damage. If necessary, install a new seal to valve mechanism cover (1). Note: Ensure that the seal is fully seated into the recess of the valve mechanism cover.
Illustration 4 g02710382
Illustration 5 g02710384
Position valve mechanism cover (1) onto the cylinder head.
Install bolts (3).
Tighten bolts (3) in the numerical sequence that is shown in Illustration 5. Tighten the bolts to a torque of 22 N m (195 lb in). Repeat Step 6 in order to ensure correct torque.
Connect plastic tube assembly to connection (2) on valve mechanism cover (1). Refer to Disassembly and Assembly, "Crankcase Breather - Remove" for the correct procedure.