VALVE GP-PILOT 2444120 - Caterpillar

Remove & Install Fuel Injection Nozzles & Adapters
Start By:a. remove valve cover 1. Disconnect fuel line nut (1). Remove nut (2) and the O-ring seal. Use Tool (A) to disconnect fuel line nut (4) and remove fuel line assembly (3).
Put protection caps on all fuel line openings.
2. Remove retainer (5) from fuel adapter with Tool (B). 3. Install nozzle puller group (C) and remove fuel nozzle from adapter. 4. Install Tool (D) and remove adapter (6). The following steps are for the installation of the fuel injection nozzles and adapters.5. Put 5P-3931 Anti-Seize Compound on the threads of the adapter before installation. Install fuel adapter (6) with Tool (D). Torque for the adapter is 200 14 N m (150 10 lb ft). 6. Install new carbon seal stop (7) with Tool (E). 7. Make sure the correct washer (8) is used when the nozzle assembly (10) is installed. Always use a new washer anytime the bleed screw (9) is loosened or removed. Install fuel nozzle assembly (10) in adapter (6). Install retainer (5) with a torque of 48 7 N m (35 5 lb ft).8. Install fuel injection line assembly (3) (finger tighten connections first). Install the O-ring seal and nut (2) with a torque of 30 7 N m (22 5 lb ft). Reconnect fuel line nut (1) with a torque of 40 7 N m (30 5 lb ft). Use Tool (A) to reconnect fuel line nut (4) with a torque of 40 7 N m (30 5 lb ft).End By:a. install valve cover