VALVE GP- 2469984 - Caterpillar

Table 1
Service Tools    
Part Number    Part    
PC Related Tools    
    Most Recent Version of Cat® Electronic Technician (Cat ET) Service Tool (1)    
    Most Recent Version of VIMSpc (2)    
    Windows-Based PC    
One of the Following Calibrated Digital Multimeters, Checkers, and Accessories    
237-5130
    Digital Multimeter    
257-9140     Digital Multimeter    
146-4080     Digital Multimeter Gp (3)    
7X-1710     Multimeter Probe    
8T-3224     Needle Tip Group    
8T-0500     Continuity Tester    
5P-7277     Voltage Tester    
Other Tools    
8T-8726     Cable Assembly (Three Pin) (3-Pin Breakout)    
6V-3000     Connector Repair Kit (Sure Seal)    
190-8900     Connector Repair Kit (Deutsch)    
175-3700     Connector Repair Kit (Deutsch DT)    
317-7484     Communication Adapter 3 Gp    
147-6456     Wedge Removal Tool    
185-3996     Thread Lock Compound    
1P-0810     Electrical Tape    
1U-5804     Calibrated Crimp Tool    
8T-0065     Silicone Sealant    
( 1 ) The most recent version of Cat® ET can be found at: https://dealer.cat.com/cda/layout?m=398435&x=7&f=882808.
( 2 ) The most recent version of VIMSpc and the most recent version of VIMSpc User Manual can be found at: https://mining.cat.com/VIMS.
( 3 ) This multimeter can use an RS232C cable to connect to a Laptop computer or Dataview tool group for troubleshooting.Cat® ET
Cat® Electronic Technician (Cat ET) Service Tool runs on a Windows-based PC. This tool is not required to determine and clear the diagnostic codes. However, the process of determining the diagnostic codes is easier and faster by using Cat ET. Cat ET can also display diagnostic code history and diagnostic code parameter status. These features allow Cat ET to be a useful tool for troubleshooting.VIMSpc
VIMSpc is a software tool used to analyze data downloaded from a machine. VIMSpc runs on a Windows-based PC and can access all the VIMSTM information for the machine.VIMSpc does not need to connect to a machine. VIMSpc can be used to generate reports that provide historical records of the operating conditions for the machine. The operating conditions represent the work environment as well as the operating parameters of the machine in the work environment. These reports can be used to monitor trends in the work environment and machine operation. Multimeters and Checkers
Use a calibrated digital multimeter to test continuity and voltage. See the instructions that are provided in the multimeter manual to operate the multimeter safely. The 7X-1710 Multimeter Probes are used to take measurements at a connector without separating the connections. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a three pin breakout and is used for sensor circuit measurements.Note: Use a 8T-0500 Continuity Tester and a 5P-7277 Voltage Tester to test a harness. Do not use a 8T-0500 Continuity Tester or a 5P-7277 Voltage Tester for electronic circuits.Connectors
Reference For Sure Seal connectors, see:
Special Instruction, SMHS7531Reference For Deutsch connectors, see:
Special Instruction, SEHS9615