AVSPARE.COM
parts catalog

VALVE GP-BANK 6 2500552 - Caterpillar



2500552 VALVE GP-BANK 6 Caterpillar parts 120H, 12H, 135H, 140H, 143H, 160H, 163H VALVE
Rating:
36
Alternative (cross code) number:
CA2500552
250-0552
2500552
Caterpillar 2500552 VALVE GP-BANK 6

Buy VALVE GP-BANK 6 2500552 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

Compatible equipment models: 2500552:

MOTOR GRADER  120H   12H   135H   140H   143H   160H   163H   Caterpillar
Number on catalog scheme: 29
 
  For full view, you need register

Information:


Only use antifreeze/coolant mixtures recommended in the Refill Capacities and Recommendations section of this manual. Failure to do so can cause engine damage.
Allow the engine to cool. Check the coolant level.
If freezing temperatures are expected, check the coolant for protection against freezing. The cooling system must be protected against freezing to the lowest expected outside temperature. Add the proper coolant/water mixture, if necessary.
Perform all required periodic maintenance on all driven equipment. Refer to the instructions that are provided by the OEM of the driven equipment.Aftertreatment Purge Cycle
Note: Air supply must remain active while the system purges.Under certain conditions the aftertreatment control system will run the DEF dosing system through a DEF purging cycle. This purge cycle will drain the AUS/DEF line between the dosing cabinet and the DEF injector. The purge cycle is designed to protect the AUS/DEF system, and to prevent the AUS/DEF from freezing. The purge cycle also protects engine exhaust hardware from AUS/DEF leaking from the DEF injector. The system will enter purge mode when the engine speed has dropped below a set threshold. The system will also enter a purge cycle if certain codes are logged during operation.During purge cycle, the AUS/DEF return valve on the AUS/DEF manifold will open and the dosing pump is turned off. The purge cycle will allow the air pressure in the line to force remaining AUS/DEF in the nozzle/line back to the tank inside the dosing cabinet. The purge cycle is a time-based event. The event should take less than 2 minutes.Note: If DC power is turned off before the purge cycle has been completed, the system will display a 3362-31: Aftertreatment #1 DEF Dosing Unit Input Lines upon start up.Shut down Procedure For the Oil Mist Detector
If a shutdown occurs due to excessive oil mist, use the following procedure.Note: Instructions from the Service Manual, "Disassembly and Assembly" module will be necessary in order to perform this procedure.
After the shutdown, inspect the control system for other alarm conditions. Compare the timing of the shutdown to the activation of the alarm. Ensure that the shutdown was initiated by the oil mist detector.
Inform the master engineer that the engine is unavailable.
Inspect the display of the oil mist detector in order to ensure that the shutdown is genuine. The green "Ready" indicator is OFF and the red "Alarm" indicator is FLASHING. Inspect the display for other faults.
After verifying the cause of the shutdown, shut off the air supply to the starting motor. This procedure will prevent accidental starting.
Open the cylinder pressure valves (Kiene valves) for all of the cylinders.
Guards must be in place prior to operating barring device motor.Remove all hand tools prior to operating barring device motor.
Do not use an impact wrench to operate the barring device. The use of an impact wrench will cause gear tooth failure.
Operate the prelube pump and the barring device. If the flywheel will rotate freely, rotate the engine for two complete revolutions (720 degrees). Lock the barring device.
Deactivate the prelube pump.
Flash fire may result

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
140H Motor Grader APM00001-UP (MACHINE) POWERED BY 3176C Engine
160H Motor Grader ASD00001-UP (MACHINE) POWERED BY 3176C Engine
143H Motor Grader APN00001-UP (MACHINE) POWERED BY 3176C Engine
163H Motor Grader ARL00001-UP (MACHINE) POWERED BY 3176C Engine
12H Motor Grader AMZ00001-UP (MACHINE) POWERED BY C-9 Engine
12H Motor Grader CBK00001-UP (MACHINE) POWERED BY C-9 Engine
120H Motor Grader ALZ00001-UP (MACHINE) POWERED BY 3126B Engine
135H Motor Grader AMX00001-UP (MACHINE) POWERED BY 3126B Engine
120H Motor Grader CAF00001-UP (MACHINE) POWERED BY 3126B Engine
135H Motor Grader CBC00001-UP (MACHINE) POWERED BY 3126B Engine
140H Motor Grader CCA00001-UP (MACHINE) POWERED BY 3176C Engine
160H Motor Grader CCP00001-UP (MACHINE) POWERED BY 3176C Engine


Parts valve Caterpillar catalog:

1457390 VALVE-INLET
120H, 120K, 12K, 12M, 135H, 140K, 140M, 160K, 3126, 3126B, 3126E, 322C, 322C FM, 324D, 324D L, 324D LN, 325C, 325C FM, 325D, 325D L, 328D LCR, 561N, 570B, 580B, 938G II, 950G II, 950H, 953C, 962G II, ...
1478211 VALVE-EXHAUST
120H, 120K, 120K 2, 12K, 12M, 135H, 140G, 140K, 140K 2, 140M, 160K, 3126, 3126B, 3126E, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D L, 325...
2527801 VALVE-INLET
120H, 120K, 120K 2, 12K, 135H, 140G, 140K, 140K 2, 140M, 160K, 3126, 3126B, 3126E, 322C, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325D, 325D FM, 325D FM LL, 325D L, 325D MH, 326D L, 328D LCR,...
2222367 VALVE GP-ACCUMULATOR CHARGING
120H, 120H ES, 120H NA, 120M, 120M 2, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14...
1P7297 VALVE-DRAIN
120G, 120H, 120H ES, 120H NA, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H, 163H NA, 16H, 215, 215B, 215C, 21...
2G1034 VALVE-AIR RELIEF
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 143H, 14G, 14H, 14H NA, 14M, 160G, 160H, 16...
6D1432 VALVE-CHECK
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160G, 160H, 160H ES, 160H NA, 160K, ...
3D2239 VALVE AS-TIRE
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 130G, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 140M 3, 160H, 160K, 160M...
4D1138 VALVE
120G, 120H, 12G, 12H, 12H NA, 130G, 135H, 140G, 140H, 140H NA, 143H, 14G, 14H, 14H NA, 160G, 160H, 163H, 16G, 16H, 16H NA, 5110B, 518, 5230, 5230B, 528, 621B, 631C, 633C, 639D, 666, 769, 769C, 769D, 7...
1104213 VALVE GP-TIRE
120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 143H,...
1161327 VALVE GP-TIRE
120H, 120H ES, 120H NA, 12H, 12H ES, 12H NA, 135H, 135H NA, 140H, 140H ES, 140H NA, 143H, 160H, 160H ES, 160H NA, 163H, 163H NA
2534347 VALVE AS-AIR
120H, 120H ES, 120H NA, 120K, 120K 2, 12H, 12H ES, 12H NA, 12K, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14H, 160H, 160H ES, 160H NA, 160K, 163H, 163H NA, 16H
2500574 VALVE GP-BANK 6
120H, 12H, 135H, 140H, 143H, 160H, 163H
2585407 VALVE MECHANISM GP
G3512E, G3516C, G3516E, G3520C, G3520E, PMG3516
2784442 VALVE GP-PUMP CONTROL
953D, D6K, D6K LGP, PL61
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.