VALVE GP-SOLENOID 2555247 - Caterpillar

Illustration 1 g00923654
Schematic of the Indicator Lamp (Scraper Mode)
This diagnostic code is associated with the Indicator Lamp (Scraper Mode). The FMI 06 means that the ECM has determined that the current of the indicator lamp is above normal. The possible causes of this diagnostic code are listed:
The energize circuit of the indicator lamp is shorted to ground.
The indicator lamp has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1297 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code occurs, a warning (Category 1) is shown on the monitor. The diagnostic code will cause the lamp to be OFF at all times.Test Step 1. CHECK THE INDICATOR LAMP.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the indicator lamp with the active diagnostic code from the machine harness. Expected Result:CID 1297 FMI 06 changes to CID 1297 FMI 05 when the indicator lamp is disconnected.Results:
YES - CID 1297 FMI 06 changes to CID 1297 FMI 05 when the indicator lamp is disconnected. The circuit is correct.Repair: The indicator lamp has failed. Repeat this test "CHECK THE INDICATOR LAMP" in order to verify the failure of the indicator lamp. Replace the indicator lamp.STOP
NO - CID 1297 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE INDICATOR LAMP FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
The indicator lamp remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact J2-40 (wire R741-GN(Green)) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-40 (wire R741-GN(Green)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1297 FMI 06. Expected Result:The CID 1297 FMI 06 is active. Results:
YES - The CID 1297 FMI 06 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again.