VALVE GP-MAIN CONTROL 2580287 - Caterpillar

Table 1
Cross-Reference for Event Codes
Flash Codes EID/FMI Codes SPN/FMI Codes Description of Code
35 004 0190-16 Engine Overspeed Shutdown
63 005 0094-15 Fuel Filter Restriction Derate
63 006 0094-16 Fuel Filter Restriction Shutdown
61 015 0110-16 High Engine Coolant Temperature Derate
61 016 0110-00 High Engine Coolant Temperature Shutdown
61 017 0110-15 High Engine Coolant Temperature Warning
64 025 0172-16 High Inlet Air Temperature Derate
64 027 0172-15 High Inlet Air Temperature Warning
46 039 0100-18 Low Engine Oil Pressure Derate
46 040 0100-01 Low Engine Oil Pressure Shutdown
62 057 0111-18 Low Engine Coolant Level Derate
62 058 0111-01 Low Engine Coolant Level Shutdown
62 059 0111-17 Low Engine Coolant Level Warning
63 095 0094-00 Fuel Filter Restriction Warning
46 100 0100-17 Low Engine Oil Pressure Warning
35 190 0190-00 Engine Overspeed Warning The ECM can log events. Events refer to engine operating conditions such as low oil pressure or high coolant temperature. Logged events usually indicate a mechanical problem instead of an electronic system problem.
Illustration 1 g00784650
Output voltage from a typical analog temperature sensor
(Coolant temperature sensor shown)
Parameters for Programmable Monitoring System
The following features are ableto be selectedin the Programmable Monitoring System (PMS) for Industrial engines.
Warning
Derate
ShutdownThe electronic technician (ET) can be used to select the monitoring features. These features can be turned ON or OFF. When an event is active, the ECM will generate an event code.The ECM will generate a EID diagnostic code on the Cat Data Link. The diagnostic code will be displayed on a diagnostic screen of the Electronic Technician (ET).The ECM will generate an SPN-FMI diagnostic code on the J1939 Data Link. The diagnostic code may be displayed on a receiving device for the J1939 data link.The ECM will generate a flash code that will be displayed on the diagnostic lamp.The Warning Lamp will display the following conditions.
Remain ON for a "Warning".
Flash for a "Derate".When a selected level is turned OFF, the ECM will log the event code but the ECM will not take any action on the event. For example, the ECM will not give a warning, a derate, or a shutdown.If multiple derates are active, the derate that limits the most power will be the derate that is shown.