VALVE GP-SOLENOID 2598194 - Caterpillar

Introduction
This Special Instruction will guide you through the procedure to replace the circuit breaker for the jacket water heater. This new circuit breaker will improve the reliability of the jacket water heater.Important Safety Information
Do not perform any procedure in this Special Instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe. Ensure that the product will not be damaged or the product will not be made unsafe by the operation, lubrication, maintenance, or repair procedures used.Required Parts
Table 1
Required Parts    
Part Number     Description     Quantity    
286-4745     Circuit Breaker     1    Replacement Procedure for the Circuit Breaker
When servicing or repairing electric power generation equipment:
Make sure the unit is either locked out or tagged DO NOT OPERATE.
Remove all fuses.
Make sure the generator engine is stopped.
Make sure all batteries are disconnected.
Make sure all capacitors are discharged.
Make sure residual voltage in the rotor, stator and the generator is discharged.Failure to do so could result in personal injury or death.
Note: Isolate the generator before beginning any type of work. Ensure proper Lock Out-Tag Out procedures are followed at all times while work is being performed on the machine. Lock out generator before beginning any type of work.
Open the generator set breaker and activate the emergency stop.
Disconnect the battery cables and the auxiliary power supply for the battery charger and heaters.
Locate the MCB12 circuit breaker on the panel chassis.
Illustration 1 g02150396
Disconnect wire 132- and wire 134- from the terminals (1) .
Remove MCB12 from the DIN rail by placing a small flat blade screwdriver into the spring loaded latch (2) .
Install the 286-4745 Circuit Breaker into the opening and ensure that the circuit breaker is locked into the DIN rail.
Reinstall wire 132- and wire 134- on the circuit breaker terminals (1) .
Reconnect any power supplies or auxiliary supplies that were disconnected in Step 2.
Verify that the jacket water is fully functional and operating correctly.