VALVE GP-CONTROL 2610015 - Caterpillar

Illustration 18 g03351546
Remove tube assembly (23).
Illustration 19 g03351673
Disconnect tube assembly (24).
Illustration 20 g03351677
Disconnect valve body (25).
Illustration 21 g03351678
Remove clips (26).
Illustration 22 g03351679
Disconnect tube assembly (27) and position tube assembly (27) out of the way.
Illustration 23 g03351681
Attach Tooling (A) and a suitable lifting device to torque converter, transmission, and output transfer gears (28). The weight of torque converter, transmission, and output transfer gears (28) is approximately 885 kg (1950 lb).
Apply suitable tension to the suitable lifting device to release pressure from the transmission mounting brackets.
Illustration 24 g03351750
Remove bolt (29).
Illustration 25 g03351751
Remove bolt (30).
Illustration 26 g03351700
Use the suitable lifting device to raise torque converter, transmission, and output transfer gears (28) enough to position suitable cribbing between bell housing (31) and rear axle (32).
Illustration 27 g03351772
Remove bolts (33). Remove mounting bracket (34).
Illustration 28 g03351795
Remove bolts (35). Remove mounting bracket (36).
Illustration 29 g03351799
Remove bolts (37).
Illustration 30 g03351801
Use Tooling (A) and the suitable lifting device to remove torque converter, transmission, and output transfer gears (28).Installation Procedure
Install torque converter, transmission, and output transfer gears (28) in the reverse order of removal.
Tighten bolts (33) and bolts (35) to a torque of 520 70 N m (385 52 lb ft).
Tighten bolts (29) and (30) to a torque of 900 100 N m (665 74 lb ft).
Apply Tooling (B) to the threads of bolt (5).
Illustration 31 g03351824
Yoke (6) must be installed in Phase with the rear yoke.
Tighten bolts (3) in an X pattern to a torque of 170 13 N m (125 10 lb ft).
Tighten bolts (1) in an X pattern to a torque of 170 13 N m (125 10 lb ft).