AVSPARE.COM
parts catalog

VALVE GP-PRESSURE REDUCING 2673196 - Caterpillar


2673196 VALVE GP-PRESSURE REDUCING Caterpillar parts 906H, 906H2, 907H, 907H2, 908H, 908H2
Rating:
57
Alternative (cross code) number:
CA2673196
267-3196
2673196
Caterpillar 2673196 VALVE GP-PRESSURE REDUCING
Weight: 0.43 pounds 0 kg.

Buy VALVE GP-PRESSURE REDUCING 2673196 Caterpillar genuine, new aftermarket tractor parts with delivery
COMPACT WHEEL LOADER,

Compatible equipment models: 2673196:

COMPACT WHEEL LOADER  906H   906H2   907H   907H2   908H   908H2   Caterpillar
Number on catalog scheme: 4
  For full view, you need register

Information:


Table 1
Diagnostic Trouble Codes
CDL Code and Description Comments
E360 (3)
Low Engine Oil Pressure - most severe (3) Oil pressure is lower than the specified pressure for at least 4 seconds. Engine will "Shut down". A snapshot is triggered. The code is logged. Factory passwords are required.
The ECM will only "Shut down" the engine if the "Engine Monitoring Mode" parameter is programmed to "Shut down".
E360 (1)
Low Engine Oil Pressure - least severe (1) Oil pressure is below the specified pressure for at least 8 seconds. A snapshot is triggered. The code is logged. Engine performance is not affected.
E360 (2)
Low Engine Oil Pressure - moderate severity (2) Oil pressure is lower than the specified pressure for at least 8 seconds. Engine power is reduced. A snapshot is triggered. The code is logged. Factory passwords are required.
After 30 seconds, the Engine Control Module (ECM) will shut down the engine if the "Engine Monitoring Mode" parameter is programmed to "Shut down". Probable Causes
Low engine oil level
Aeration in the oil
Low oil viscosity
Plugged Oil Filter
Faulty oil pump
Faulty engine oil pressure sensor
Faulty bypass valve
Damaged suction tube or cracked suction tube
Excessive wear of engine componentsRecommended Actions
Table 2
Troubleshooting Test Steps Values Results
1. Check the Engine Oil Level
A. Check the engine oil level in the crankcase. Refer to the Operation and Maintenance Manual for calibration of the dipstick gauge.
Engine oil level
Result: The engine oil is OK.
Proceed to Test Step 2.
Result: The engine oil level is NOT OK.
Repair: Add engine oil in order to obtain the correct engine oil level. Refer to Operation and Maintenance Manual, "Engine Oil" for the recommendations of engine oil.
Start the engine. Inspect the exterior of the engine for oil leaks. Repair any oil leaks.
If the problem is not resolved, proceed to Test Step 2.
2. Check for Aeration

Caterpillar parts catalog:

Caterpillar parts catalog
906H Wheel Loader TPE00001-UP (MACHINE) POWERED BY 3044C Engine
907H Wheel Loader MJF00001-UP (MACHINE) POWERED BY 3044C Engine
908H Wheel Loader MXF00001-UP (MACHINE) POWERED BY 3044C Engine
906H Wheel Loader SDH00001-UP (MACHINE) POWERED BY C3.4 IND Engine
908H Wheel Loader LMD00001-UP (MACHINE) POWERED BY C3.4 IND Engine
907H Wheel Loader SJM00001-UP (MACHINE) POWERED BY C3.4 IND Engine
906H2 Wheel Loader JRF00001-UP (MACHINE) POWERED BY C3.3B Engine
908H2 Wheel Loader JRD00001-UP (MACHINE) POWERED BY C3.3B Engine
907H2 Wheel Loader JRS00001-UP (MACHINE) POWERED BY C3.3B Engine
D10T2 TRACK-TYPE TRACTOR JJW00001-UP (MACHINE) POWERED BY C27 Engine
D10T2 TRACK-TYPE TRACTOR RAB00001-UP (MACHINE) POWERED BY C27 Engine


Parts valve Caterpillar catalog:

8C3446 VALVE-FLUID SAMPLING
1090, 1190, 1190T, 120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 1290T, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 1390, 140B, 140G, 140H, 140H ES, 1...
3E4058 VALVE AS
1090, 1190, 1190T, 120G, 120H, 120H ES, 120H NA, 120M, 1290T, 12G, 12H ES, 12H NA, 12M, 130G, 135H, 135H NA, 1390, 140G, 140H ES, 140H NA, 143H, 14H, 14H NA, 160H ES, 160H NA, 163H NA, 16G, 16H NA, 16...
6V7238 VALVE-SHUTOFF
1090, 1190, 1190T, 120K, 120K 2, 120M, 120M 2, 1290T, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 1390, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 214B, 2...
2289240 VALVE GP-RELIEF
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 247, 247B, 247B3, 248, 252B, 252B3, 257B, 257B3, 257D, 259B3, 259D, 267, 267B, 268B, 272C, 287, 297C, 299C, 906H, 9...
2335470 VALVE-EXHAUST
236B, 236B3, 242B3, 246C, 252B, 252B3, 256C, 257B3, 259B3, 262C, 262C2, 267B, 268B, 272C, 277C, 277C2, 279C, 279C2, 287C, 287C2, 289C, 289C2, 297C, 299C, 3044C, 315C, 317B LN, 318B, 906, 906H, 907H, 9...
2335469 VALVE-INLET
236B, 236B3, 242B3, 246C, 252B, 252B3, 256C, 257B3, 259B3, 262C, 262C2, 267B, 268B, 272C, 277C, 277C2, 279C, 279C2, 287C, 287C2, 289C, 289C2, 297C, 299C, 3044C, 315C, 317B LN, 318B, 906, 906H, 907H, 9...
1349911 VALVE-CHECK
226B, 226B3, 242B, 247B, 257B, 725, 730, 730C, 735, 735B, 740, 740B, 906H, 906H2, 907H, 907H2, 908H, 908H2, AP-1000B, AP-1055B, AP-655C, AP-900B, BG-2455C, BG-245C, D250E II, D300E II, D350E II, D400E...
3433302 VALVE GP-CHECK
950H, 950K, 962H, 962K, 966H, 966K, 972H, 972K, 980K, IT62H
3699449 VALVE GP-SHUTTLE
938H, 950H, 950K, 962H, 962K, 966H, 966K, 972H, 972K, 980K, IT38H, IT62H
2722334 VALVE GP-RELIEF
950H, 950K, 962H, 962K, 966H, 966K, 972H, 972K, 980K, 980K HLG, IT62H
2775676 VALVE GP-SOLENOID
906H, 906H2, 907H, 907H2, 908H, 908H2, 910K, 914K, CB-44B, CB-54, CB-54B, CB-64, CD-54B, CW-14
1971361 VALVE GP-RELIEF
906H, 906H2, 907H, 907H2, 908H, 908H2, CB-44B, CB-534C, CB-54B, CB-634C, CB-634D, CD-54B, CP-56, CP-573E, CP-64, CP-663E, CP-76, CS-531D, CS-533D, CS-54, CS-56, CS-563D, CS-563E, CS-573D, CS-583D, CS-...
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.