VALVE GP-CHECK 2736499 - Caterpillar

This warning label is located on the electric masts. The warning label is placed to the rear of the masts at eye level.
Illustration 1 g01069921
Warning decal that is located on the electric masts
To prevent possible personal injury during installation and removal of the laser receivers, lower the mast to the minimum height and use an approved access system to reach the mounting locations of the laser receivers at the top of the mast. Do not climb on the blade.
Note: The warnings for the movement of the blade while the machine is in automatic mode have been incorporated into this manual in order to address the portability of the display. These warnings apply when the display has been removed from an excavator and placed on a machine that incorporates automatic modes.
Unexpected blade movement may occur when the blade control system is in automatic mode. Unexpected blade movements that occur while mounting or dismounting the machine may result in injury or death. Before dismounting the machine, always place the automatic blade control system into manual mode and follow the machine parking procedures specified in the machine Operation Manual.
Once the system is placed in automatic mode, blade movement may occur. Blade movement may exceed 21 cm (8 inches). Injury or death from crushing could occur. Ensure that all personnel are clear of the blade before you place the system in automatic mode.
This warning label is located on the tripod. The label is placed in a location on each leg of the tripod in order to be easily seen.
Illustration 2 g01073304
Warning decal that is located on the legs of the laser transmitter
Movement of the transmitter could cause unexpected blade movement. Death or serious injury could occur. Turn off the transmitter before you move the transmitter or before you adjust the transmitter.
Safety (Laser)
The IEC and the United States Government Center of Devices for Radiology Health (CDRH) has classified this laser as a Class II laser product. The maximum radiant power output of this laser is less than 5 milliwatts.Refer to the operator's manual of the laser transmitter for installation and operating instructions.The laser that is supplied with the AccuGrade - Laser System complies with all applicable portions of "Title 21" of the "Code of Federal Regulations, Department of Health and Human Services, Food and Drug Administration, Federal Register, Volume 50, Number 161, 20August 1985".This laser complies with "OSHA Standards Act, Section 1518.54" for use without eye protection. Eye protection is not required or recommended. The following safety rules should be observed:
Never look into a laser beam or point the beam into the eyes of other people. Set the laser at a height that prevents the beam from flashing directly into people's eyes.
Do not remove any warning signs from the laser.
Use of this product by personnel that are not trained on this product may result in exposure to hazardous laser light.
If initial service requires the removal of the outer protective cover, removal of the cover must be performed by trained personnel.Crushing Prevention and Cutting Prevention
Support the