VALVE GP-RELIEF 2795771 - Caterpillar

Sliding window glass assemblies (groups) are removed and installed with same procedure.
If it is necessary to remove damaged glass, use thick gloves to avoid injury.
1. Put tool (A) in between the two lips of seal (1) as shown. Move tool (A) along the seal to pull the locking lip out away from the cab. Move the tool completely around the circumference of the glass.
TYPICAL EXAMPLE2. With locking lip out, remove the glass from the opening. Remove seal (1) from the edge of the window opening.Install Cab Window Glass
Handle glass carefully.
TYPICAL EXAMPLE1. Start along the side of the window panel opening to install seal (3). Install edge (4) of seal over panel (5) with the locking lip toward the outside of the cab. When the glass is installed, edge (2) must be over glass (1) as shown.
TYPICAL EXAMPLE2. Install the seal around the circumference of the window opening. Cut the seal to extend past the starting point by .125 in. (3.18 mm) per foot of window opening circumference. Push the ends of the seal together and push them over the body panel to make a tight, smooth joint.3. Put the lower corner of the glass in the channel of the seal as far as possible. Do not use too much force. 4. Move in both directions from the starting point, lift the glass channel lip and the glass will slip into place.5. Put a solution of soap and water on the locking lip of the seal. 6. Install the curved end of tool (A) or (7) between locking lip (6) and its groove (8) at any point away from the seal joint. 7. Move the tool along groove (8) as shown. 8. Move tool (A) completely around the circumference of seal, the rubber lip will lock into position around the circumference of the glass.