VALVE GP-SOLENOID 2796530 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     6V-2082     Lifting Hook     1    
ZZ     6V-9508     Face Seal Plug (11/16 - 16 THD)     1    
6V-9829 Cap As (11/16 - 16 THD)     1    
6V-9509 Face Seal Plug (13/16 - 16 THD)     1    
6V-9830 Cap As (13/16 - 16 THD)     1    
6V-9511 Face Seal Plug (1 7/16 - 12 THD)     3    
6V-9832 Cap As (1 7/16 - 12 THD)     3    Start By:
Tilt the cab, if equipped. Refer to Disassembly and Assembly, "Cab - Tilt".
Tilt the operator platform, if equipped. Refer to Disassembly and Assembly, "Operator Platform - Tilt".Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
Illustration 1 g00812382
Disconnect hose assemblies (1) and (2) from vibratory pump (3) .
Illustration 2 g00812383
If equipped, disconnect fitting (4) from the propel pump. Move the fitting and hose assemblies out of the way.
Remove bolt (7) and move hose assembly (8) out of the way.
Remove bolt (5) and move harness assembly (6) out of the way.
Illustration 3 g00812385
Disconnect hose assembly (9) from the bottom of the vibratory pump.
Illustration 4 g00812386
Disconnect harness assembly (10) .
Illustration 5 g00812387
Attach Tooling (A) and a suitable lifting device to vibratory pump (3) .
Remove bolts (11). Remove vibratory pump (3) from the propel pump. The weight of the vibratory pump is approximately 40 kg (88 lb).