VALVE GP-SHUTTLE 2827760 - Caterpillar

1. Pry retainer (1) from cap (2), and remove cap (2) and the diaphragm from the brake reservoir.2. Disconnect tube assembly (4) from brake reservoir assembly (5), and drain the brake fluid from the reservoir.3. Put the diaphragm and cover (2) in position on the brake reservoir, and pry retainer on to the cap to prevent introduction of dirt and foreign material.4. Remove four bolts (3) that hold brake reservoir (5) to the bracket assembly. 5. Open the access door located in the rear of the hood, and remove brake reservoir (5) from the machine.6. Repeat Steps 1 through 5 to remove the other brake reservoir.Install Brake Reservoirs
1. Open the access door located in the rear of the hood, and put brake reservoir (1) in position on the bracket assembly as shown. 2. Install four bolts (4) that hold brake reservoir (1) to the bracket assembly.3. Connect tube assembly (5) to the bottom of brake reservoir (1).4. Pry retainer (2) from cap (3), and remove cap (3) and diaphragm from the brake reservoir. Repeat Steps 1 through 4 to install the other brake reservoir.5. Fill the brake reservoirs with brake fluid to the correct level. See the Maintenance Guide.6. Remove (bleed) the air from the brake system. See Remove Air From The Wheel Brake Hydraulic Circuit (Bleed The Brakes) in Testing And Adjusting.