VALVE GP-STEERING 3080934 - Caterpillar

Table 5
Failure Mode Identifier Valid Options
Category Suspect Parameter Number Category High Shutdown Low Shutdown High Warning Low Warning Status
Pressures Engine Oil Pressure X X X(1)
Gas Pressure X X X X
Temperatures Engine Coolant Temperature X X X
Engine Oil Temperature X X X X X(1)
Exhaust Temperature X X X
Generator Rear Bearing Temperature X X X X
Generator Winding #1 Temperature X X
Levels Engine Coolant Level X X X X
Engine Oil Level X X X X
Fuel Level X X X X
External Tank Fuel Level X X X X
Others Air Damper Closed X
Battery Charging System Voltage X
Battery Charger Failure X
Custom Event (see note below) X
Earth Fault X
Earth Leakage X
Emergency Stop Switch X(2)
EPS Supply Load X
Fuel Leak X
Generator Breaker Closed X
Generator Breaker Open X
Generator Current X X X X
Generator Real Power X X X
Inlet Manifold Charge Combustion X
(1) This status is FMI 14 (Special Instruction), not FMI 31 (Condition Exists).
(2) The status is FMI 14 (Special Instruction), not FMI 31 (Condition Exists). The FMI provides a means to differentiate between a Remote Emergency Stop and Emergency Stop.Note: For custom events, each input can only trigger the custom event number that matches the digital input number. Digital input #1 can only activate custom event #1, and so on.Configuring Digital Inputs for SCADA Datalink
Illustration 54 g02265613
Double click the "Digital Input #N Usage Type" to change this value to "Data Link" from the drop-down menu. Click the"OK" button to program.Disabling Digital Inputs
Illustration 55 g02265673Double click the "Digital Input #N Usage Type" to change this value to "Disabled" from the drop-down menu. Click the "OK" button to program.