parts catalog

VALVE-CHECK 3237239 - Caterpillar

3237239 VALVE-CHECK Caterpillar parts VALVE
Alternative (cross code) number:
Caterpillar 3237239 VALVE-CHECK
Weight: 0.07 pounds 0 kg.

Buy VALVE-CHECK 3237239 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2674 Vacuum Cap 1
B 1U-9200 Lever Puller Hoist 1
C 439-3938 Link Bracket 2 Start By:
Release the hydraulic system pressure.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g01344378
Typical Example
Install Tooling (A) onto the hydraulic tank . Attach an air supply hose onto Tooling (A). Apply 276 414 kPa (40 60 psi). This procedure will pull a vacuum on the hydraulic system.
Illustration 2 g01344679
Remove bolts (2) and covers (1).
Illustration 3 g01344678
Disconnect hose assemblies (6). Disconnect fitting (7). Disconnect hose assemblies (3). Remove fittings (5). Remove bolts (4).
Illustration 4 g01349819
Remove bolts (9) and platform assembly (8).
Illustration 5 g01343207
Disconnect hose assemblies (10). Remove the bolts from bracket (11). Reposition bracket (11) out of the way.
Illustration 6 g01343208
If necessary, use Tooling (B) to secure the hose assemblies out of the way. Disconnect the hose assembly and remove fitting (12). Remove support (17). Loosen clamp (13). Remove bolts (14), retainer (15), and boot (16).
Illustration 7 g01344693
Attach Tooling (C) and a suitable lifting device to swivel (18). The weight of swivel (18) is approximately 102 kg (225 lb). Remove swivel (18).Installation Procedure
Install swivel (18) in the reverse order of removal.

Parts valve Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.