VALVE GP-SOLENOID & RELIEF 3350084 - Caterpillar

Table 6
Alternative     Default    
"Yes"     "No"    "Maximum PTO Enable Speed"
This parameter specifies the maximum engine speed for the engagement of the PTO mode. The PTO mode will engage when the engine rpm is equal to the programmed limit or less than the programmed limit.
Table 7
Minimum     Maximum     Default    
700 rpm     TEL rpm     TEL rpm    "PTO Cab Throttle RPM Limit"
This determines the engine rpm limit of the pedal position sensor for the cab accelerator and cab set/resume switch when "PTO Configuration" is programmed to "Cab Switches" and the PTO on/off circuit is ON. This parameter is intended to prevent engine overspeed when the dedicated PTO is used.
If the parameter is programmed to "Low Idle", the cab controls are ignored.
If the parameter is programmed to "Top Engine Limit" (TEL), the engine will operate to the programmed "Top Engine Limit".
If the parameter is programmed to "PTO Top Engine Limit", the engine will operate to the programmed "PTO Top Engine Limit".Note: "PTO Configuration" must be programmed to "Cab Switches" for this parameter to take effect. If "PTO Configuration" is programmed to "Remote Switches" or to "Remote Throttle", the ECM will always ignore the cab controls when the PTO on/off circuit is on.
Table 8
Alternative     Default    
Low Idle, TEL and PTO TEL     TEL    "PTO Kickout Vehicle Speed Limit "
This is the maximum vehicle speed for setting or maintaining a set engine rpm in PTO mode. PTO mode is entered if the PTO on/off switch is on. (This uses input 1.) If the vehicle speed signal exceeds this value, the engine will not maintain the set engine rpm.
Table 9
Minimum     Maximum     Default    
2 km/h (1 mph)    
204 km/h (127 mph)    
2 km/h (1 mph)    "Maximum PTO Vehicle Speed"
This parameter specifies the maximum vehicle speed that is allowed when PTO mode is active. The engine will be derated in order to maintain this vehicle speed when the PTO mode is active.
Table 10
Minimum     Maximum     Default    
5 km/h (3 mph)    
204 km/h (127 mph)    
204 km/h (127 mph)    "Torque Limit"
Illustration 1 g00628600
Operation of Torque limit (1) Programmed torque limitThe parameter for the "Torque Limit" defines the maximum torque output of the engine during dedicated PTO operation. This parameter provides temporary protection of equipment. The "Torque Limit" of the engine is active when the circuit for the torque limit switch is on. The maximum value is the rated torque of the engine. The "Torque Limit" is programmable to N m (lb ft) of torque. Programming a value higher than the rated torque is limited by the ECM to rated torque. The torque limit is indicated by the dashed line in Illustration 1.
Table 11
Minimum     Maximum     Default    
135 N m (100 lb ft)    
2712 N m (2000 lb ft)    
2712 N m (2000 lb ft)    "PTO Shutdown Time"
The "PTO Shutdown Time" is the