VALVE GP-SOLENOID 3516053 - Caterpillar

Start By:
Remove the centrifugal oil filter. Refer to Disassembly and Assembly, "Centrifugal Oil Filter - Remove and Install".Note: A CWS login is required to access Caterpillar Channel 1.Reference: For additional information, view "C175 Centrifugal Oil Filter Clean for 797 Off-Highway Trucks" on Caterpillar Channel 1.Englishhttps://channel1.mediaspace.kaltura.com/media/C175+Centrifugal+Oil+Filter+Clean+for+797+Off-Highway+Trucks/1_j1rgf35v
Spanishhttps://channel1.mediaspace.kaltura.com/media/Filtro+de+aceite+centr%C3%ADfugo+C175+limpio+para+797+camiones+fuera+de+carretera+%28Spanish%29/1_4sz0t21i
Portuguesehttps://channel1.mediaspace.kaltura.com/media/Filtro+de+%C3%B3leo+centr%C3%ADfugo+C175+limpo+para+797+caminh%C3%B5es+fora+de+estrada++%28Portuguese%29/1_o0si7vob
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g06289047
Loosen clamp (3) and nut (1). Remove cover (2) from the filter base.
Illustration 2 g06289052
Remove O-ring seal (4) from the filter base.
Illustration 3 g06289059
Remove rotor assembly (5) from the filter base.
Illustration 4 g06318019
Illustration 5 g06317282
Secure Tooling (A) in a bench vise. Place a socket on Tooling (A) to hold rotor assembly (5).
Loosen nut (6) and remove cover (7).
Remove clip (8) and O-ring (9).
Illustration 6 g06317287
Remove the paper liner (10) from rotor tube (11).
Illustration 7 g06317291
Remove rotor tube (11) and O-ring (12).
Remove plate (13).
Illustration 8 g06317315
Remove clip (14) and O-ring (16) from spindle (15).
Use Tooling (B) to measure the clearances between bushing (17) and spindle (15).The maximum clearance between bushing (17) and spindle (15) is 0.15 mm (0.006 inch).
Illustration 9 g06317319
Use Tooling (B) to measure the clearances between bushing (18) and spindle (15).The maximum clearance between bushing (18) and spindle (15) is 0.15 mm (0.006 inch).
Illustration 10 g06317336
Remove pin (19) and remove tube (21).
Remove retainer (20) from the cover assembly.
Illustration 11 g06317347
Remove O-ring (22) from retainer (20).