VALVE GP-CONTROL 3630756 - Caterpillar

3630756 VALVE GP-CONTROL Caterpillar parts H110E S

Price: query

Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3630756
363-0756
3630756

Buy VALVE GP-CONTROL 3630756 Caterpillar genuine, new aftermarket tractor parts with delivery
HAMMER,

Compatible equipment models: 3630756:

HAMMER H110E S Caterpillar

Number on catalog scheme: 15

Caterpillar 3630756 Parts scheme VALVE GP-CONTROL

For full view, you need register

Caterpillar SIS machinery equipment:

Caterpillar SIS

H110E S, H115E S, H120E S, H130E S, H140E S, H160E S, H180E S Hydraulic Hammers HHB00001-UP (MACHINE) » 363-0756 VALVE GP-CONTROL

Caterpillar parts catalog:

Caterpillar parts catalog
Product:

H110E S, H115E S, H120E S, H130E S, H140E S, H160E S, H180E S Hydraulic Hammers HHB00001-UP (MACHINE)

363-0739: POWER GP-HAMMER » SEBP56360050
363-0739: POWER GP-HAMMER » SEBP56360050

Information:

Illustration 1 g00754738
Front ViewAdjustment of Input Gear End Play
Illustration 2 g00754739
(1) Upper cage bolts (2) Shims (3) Case (4) Cage (5) Input gear (6) Seal (7) Lower cage bolts (8) Cage (9) Seal (10) Output ShaftNote: The bearing axis must be vertical for correct end play adjustment.
Before assembly of the components, make sure that the bearing cups and the bearing cones are seated in the housing by using a 0.038 mm (.0015 inch) shim or a standard feeler gauge.
Use two cage bolts (1) in order to install cage (4) to case (3). The cage bolts are separated by a distance of 180 degrees. Do not install shims (2) or seal (6) .
Tighten the two cage bolts (1) to a torque of 1.7 N m (15 lb in).
Turn gear (5) at least three revolutions in order to seat the bearings.
Tighten the two cage bolts (1) to a torque of 3.4 N m (30 lb in).
Turn gear (5) at least three revolutions in order to seat the bearings.
Two cage bolts (1) should again be tightened to a torque of 3.4 N m (30 lb in).
Measure the gap between case (3) and cage (4) at the two cage bolts (1). Perform the measurement between the outside diameter of the flange and the cage bolts.
Average the two measurements from Step 8. Add 0.33 mm (.013 inch) to the average. This result is the required thickness of shims (2) .
Remove the cage. Reassemble the cage with required shims (2) from Step 9 and with O-ring seal (6) .