VALVE & LINES GP-HYD CONTROL 3783868 - Caterpillar

Illustration 2 g06314855
Illustration 3 g02458377
Use Tooling (D) and (G) to lower the upper structure onto the undercarriage in increments of 13 mm (0.5 inch). The weight of upper structure (14) is approximately 22217 kg (48980 lb). Refer to Tool Operating Manual, NEHS1328, "Lift Groups (Stand - 60 Ton)" for more information on Tooling (G).
Illustration 4 g02458501
Illustration 5 g02458500
Remove Tooling (F). Install two bolts (17). Install remaining bolts (17). Torque bolts (17) to a torque of 900 100 N m (665 75 lb ft). Install tube assembly (16).
Illustration 6 g06355109
Attach a suitable lifting device to Tooling (E) and remove Tooling (E) from Tooling (G).
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the work tool hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Illustration 7 g02458416
Install clamp (13), retaining ring (12), and bracket (11). Connect hoses (10).
Illustration 8 g02458396
Attach a suitable lifting device to Tooling (B). Tooling (B) weighs approximately 408 kg (900 lb). Remove plate (7) and bolts (6).
Illustration 9 g02458380
Attach a suitable lifting device to boom cylinder (8). boom cylinder (8) weighs approximately 380 kg (840 lb). Using Tooling (J) to drive pin (9).
Illustration 10 g02458379
Install plate (7) and bolts (6). Install hose assembly (5).
Illustration 11 g02458360
Install ring gear (4) and bolts (3) into cover assembly (2). Apply Tooling (K) onto cover assembly (2). Fill final drive with oil. Refer to Operation and Maintenance Manual, "Final Drive - Oil Change".
Illustration 12 g02458357
The planetary gear group is being held onto the sprocket housing at this time only by Tooling (H). The approximate weight of the planetary group is 163 kg (360 lb). Be careful not to allow the planetary gear group to slide outward.
Illustration 13 g02458336
Install cover assembly (2). Install bolts (1). Remove Tooling (H). Install remaining bolts (1). Torque bolts (1) to a torque of 105 20 N m (80 15 lb ft).
Fill each final drive. Refer to Operation and Maintenance Manual, "Final Drive Oil - Change".End By:
Install the bucket.