VALVE GP-MAIN CONTROL 3939241 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-7498     Support Stand As     4    
1U-7501 Extension Tube     4    
B     138-7573     Link Bracket     3    
C     323-1146     Engine Lifting Device     1    
D     -     Loctite 596     -    
Illustration 1 g01559213
Install the oil pan gasket.Note: Apply Tooling (D) to the puzzle joints and the T joints on the gasket. Apply between the cylinder block face, the front housing, and the rear housing.
Attach Tooling (B) and a suitable lifting device onto engine oil pan (15). The weight of engine oil pan (15) is approximately 567 kg (1250 lb). Position engine oil pan (15) onto platform (16). Reach through the holes in platform (16) in order to install bolts (17) .
Illustration 2 g01559193
Attach Tooling (C) onto the engine. The weight of the engine is approximately 10343 kg (22802 lb). Remove the engine from Tooling (A) .
Illustration 3 g01559173
Lower the engine onto engine oil pan (15) .
Illustration 4 g01559153
Install bolts (14) on all sides of engine oil pan (15) .
Illustration 5 g01214573
Connect tube assembly (13) .
Illustration 6 g01559113
Connect harness assemblies (12) and (11) .
Illustration 7 g01559133
Connect hose assemblies (10), (9), and (8) .
Illustration 8 g01559073
Connect hose assemblies (5) and (6) onto fuel filter housing (7) .
Illustration 9 g01214538
Install elbow (4) onto engine oil pump (1). Install bolts (2) and bolts (3) .
Fill the engine with oil. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".
Turn the fuel supply valve to the ON position.
Turn the battery disconnect switch to the ON position.