VALVE-CHECK 3N6935 - Caterpillar

Before performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood.Note: Use fuel consumption, service hours, or calendar time, whichever occurs first , in order to determine the maintenance intervals. Engines that operate in severe operating conditions may require more frequent maintenance.Note: For information on generator maintenance, see the Operation and Maintenance Manual for the generator.The maintenance that is recommended for Every Week can be performed by an authorized operator. The maintenance that is recommended for the subsequent maintenance intervals must be performed by an authorized service technician or by your Caterpillar dealer.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.When Required
Fuel System - Prime
Generator Load - Check
Generator Set - Test
Rotating Rectifier - Test
Every Week
Air Inlet Filter - Check
Automatic Start/Stop - Inspect
Battery Charger - Check
Battery Electrolyte Level - Check
Bearing Temperature - Measure/Record
Cooling System Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Instrument Panel - Inspect
Jacket Water Heater - Check
Power Factor - Check
Radiator - Clean
Standby Generator Set Maintenance Recommendations
Every Year
Alternator - Inspect
Alternator and Fan Belts - Inspect/Adjust/Replace
Bearing - Lubricate
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Performance - Test
Engine Protective Devices - Check
Engine Valve Lash - Inspect/Adjust
Fan Drive Bearing - Lubricate
Fuel System Primary Filter/Water Separator Element - Replace
Fuel System Secondary Filter - Replace
Generator - Dry
Generator Set Vibration - Inspect
Hoses and Clamps - Inspect/Replace
Insulation - Test
Magnetic Pickups - Clean/Inspect
Standby Generator Set Maintenance Recommendations
Starting Motor - Inspect
Water Pump - Inspect
Every 3 Years
Belts - Replace
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Hoses and Clamps - Replace
Rotating Rectifier - Check
Standby Generator Set Maintenance Recommendations
Turbocharger - Inspect
Every 6 Years
Cooling System Coolant (ELC) - Change
Standby Generator Set Maintenance Recommendations
Overhaul
Bearing - Inspect