VALVE GP-SEQUENCE & PRESS CONT 3P0216 - Caterpillar

Remove two bolts (2). Position neutralizer valve (1) out of the way.
Illustration 2 g01192738
Disconnect wiring harness (4) at the connector.
Remove four bolts (3). Remove pressurizer assembly (5) .
Illustration 3 g01192717
Remove five bolts (7). Remove fender (6) .
Illustration 4 g01192719
Remove cover (8) .
Illustration 5 g01192720
Disconnect three electrical connectors (9) .
Illustration 6 g01192721
(A) Cab (B) Rear frame
Remove bolt (11). Disconnect ground wire (10) .
Illustration 7 g01192722
Disconnect ten hose assemblies (13) from the bulkhead.
Disconnect the fire suppression hose from the bulkhead (if equipped).
Illustration 8 g01192739
Disconnect air conditioning hose assemblies (14) and (15) (if equipped).
Illustration 9 g01192725
Remove cover (16) .
Illustration 10 g01192727
Remove four bolts (18) from mount (17) .
Illustration 11 g01192731
Remove two nuts (20). Position service brake control valve (19) out of the way.
Illustration 12 g01192732
Install Tooling (A) and a suitable lifting device to the cab. The weight of the cab is approximately 1250 kg (2756 lb).
Remove the bolts from pin assemblies (21). Remove pin assemblies (21) .
Illustration 13 g01192746
Remove three bolts (22) .
Remove the cab. Support the cab.
Illustration 14 g01192734
Remove two bolts (24). Remove two caps (23) and the two mounts.
Illustration 15 g01192736
Remove the cab from mount assembly (26) .
Remove two mounts (25) from mount assembly (26) .