VALVE AND LINES GROUP 3P5943 - Caterpillar

Image1.1.1
At the Machine:
2. Connect to the PLE601 following the instructions from REHS8850, section "Flashing the PLE601 Network Manager". If no Network Manager is detected, check all wiring and connections and try again. If the Network Manager continues to not be detected, contact the Product Link hardware support hotline to assist with troubleshooting and to verify a hardware failure PRIOR to device replacement. Dial the DSN phone number at 309-636-8500 and select Prompt #2. If the Network Manager is detected, proceed to Step 3. After troubleshooting steps are conducted and verified and the Network Manager is determined to need replacing, a validation number will be provided that will need to be included within the claim. Any claims that do not include this validation number for failed hardware will be reviewed for potential debiting of the claim amount. If hardware replacement is necessary, replace with a different PLE601 Network Manager as per the ?Network Manager Replacement? section of REHS8850. Ensure the failed PLE601 is retained to send it back. Refer to the Parts Disposition. An ?After Failure? claim will need to be filed using the 20R6220 reman part number.
3. If the Network Manager did not need to be replaced:
A. Download a Cat Electronic Technician (Cat ET) Product Status Report.
B. Use the ECM replacement functionality in Cat ET and save the file locally.
C. Download all VIMS data, using VIMSpc (if applicable).
D. If using Truck and Material ID lists used with the Cat Production Measurement system, ensure all lists are copied and saved.
E. Navigate to the Service Dashboard and note any standard/customer configuration files, and any custom settings (ECM Exclusions, Modbus configurations, etc.).
4. Flash the PLE601 with the part number as seen in Image 1.1.1 (or later if available). If flash completes in less than 35 minutes, proceed to step 5. If during the flash, flash time exceeds 35 minutes, cycle power from asset using master disconnect. If no disconnect is present, remove 70-pin connector for 10 seconds before replacing. Ensure that Cat ET is completely shut down, and the laptop connection is removed from the asset for at least 3 minutes. Reconnect to the asset, and attempt the flash again - if flash continues to take longer than 35 minutes, contact the Product Link hardware support hotline to assist with troubleshooting and to verify a hardware failure PRIOR to device replacement. Dial the DSN phone number at 309-636-8500 and select Prompt #2. After troubleshooting steps are conducted and verified and the Network Manager is determined to need replacing, a validation number will be provided that will need to be included within the claim. Any claims that do not include this validation number for failed hardware will be reviewed for potential debiting of the claim amount. If hardware replacement is necessary, replace the Network Manager as per the ?Network Manager Replacement? section of REHS8850. Ensure the failed PLE601 is retained to send it back. Refer to the Parts Disposition. An ?After Failure? claim will need to be filed using the 20R6220 reman part number.
PLEASE BE AWARE: When