VALVE GP-LUBE DISTRIBUTION 4172736 - Caterpillar

Illustration 1 g01113544
(1) Apply 5P-3413 Pipe Sealant to four plugs before installing. (2) Thickness of four new disc assemblies and three new plates for brake ... 28.34 0.96 mm (1.116 .038 inch)Thickness of one new 6Y-9373 Friction Disc Assembly ... 4.70 0.18 mm (.185 .007 inch)Thickness of one new 7T-6994 Plate ... 3.18 0.08 mm (.125 .003 inch) (3) Use shims in order to obtain the following backlash between the bevel gear and the pinion shaft. ... 0.210 0.075 mm (.0083 .0030 inch) (4) Tighten the nut until the rotating torque of the pinion shaft is 0.3 to 1.35 N m (3 to 12 lb in).Bend the tab on the lock washer into the slot in the nut.Note: Tighten the nut before the bevel gear is installed. (5) Inside diameter of new planetary gears ... 58.298 0.010 mm (2.2952 .0004 inch) (6) Diameter of new shafts for planetary gears ... 42.395 0.008 mm (1.6691 .0003 inch) (7) Diameter of new shafts for planetary gears ... 42.395 0.008 mm (1.6691 .0003 inch) (8) Inside diameter of new planetary gears ... 51.948 0.010 mm (2.0452 .0004 inch) (9) Apply 6V-6640 Sealant to the flange of the slinger in the area that makes contact with the carrier. (10) Make sure that the three washers are equally spaced. (11) Torque for three bolts ... 50 10 N m (37 7 lb ft)Bearing Preload Procedure for Housing (12)
Install the rotating housing (12) with bearings into the brake housing.
Install plate (13) with three equally spaced bolts (14) .
Tighten bolts (14) until the rotating torque for housing (12) is 2.25 to 4 N m (20 to 35 lb in).
Measure the gap between plate (13) and housing (12). Install shims (15) that are equal to the measured gap.
Recheck rotating torque.
Illustration 2 g00552140
Position of the Belleville Spring during installation