VALVE GP-CHECK 4346464 - Caterpillar

Illustration 25 g02267975
(1) Cabinet style spray washer (6) Wheel assembly
Place the wheel assembly (6) inside the cabinet style spray washer (1). Refer to Illustration 25.
Operate cabinet style spray washer (1) until clean. Normal cycles are approximately 30 minutes.
Illustration 26 g02267635
793 Wheel assembly where oil and contaminants accumulate
Illustration 27 g02267636
797 Wheel assembly where oil and contaminants accumulate
Inspect the wheel assembly cavity with a good light source to ensure that all debris is removed.
Remove wheel assembly (6) and cover with protective covering.
Illustration 28 g02268039
(21) Lifting Eyebolts (22) Spindle
Spindle Setup
797 Setup-Attach two 111-7927 Eyebolts (21) to spindle (22). Attach lifting eye bolts to a suitable lifting device. The weight of the 797 spindle is 1691 kg (3728 lb). Refer to Illustration 28.
793 Setup-Attach two 3E-3880 Eyebolts to spindle. Attach the lifting eye bolts to a suitable lifting device. The weight of the 793 spindle is approximately 1014 kg (2235 lb).
Illustration 29 g02269493
(1) Cabinet style spray washer (22) Spindle
Place the spindle (22) inside the cabinet style spray washer (1). Refer to Illustration 29.
Operate cabinet style spray washer (1) until clean. Normal cycles are approximately 30 minutes.
Illustration 30 g02266154
(11) Spindle cavity (12) 1U-9140 Shop Vacuum
Remove the spindle and vacuum all fluid out of the wheel assembly and the spindle using the Shop Vacuum (12). Make sure that the vacuum hose is clean before use. Refer to Illustration 30.
Illustration 31 g02267533
(11) Spindle cavity (15) Light source
Inspect spindle with a good light source (15). If any fluid remains, repeat Step 6 through Step 8. Refer to Illustration 31.
Illustration 32 g02267574
(11) Spindle cavity (18) 162-5791 Towel -lint free wipes
Use Towel-lint free wipes to test for acceptable cleanliness levels in all cavities and on the surface of the spindle and wheel assembly. Refer to Illustration 32.
Illustration 33 g02267554
(11) Spindle cavity (15) Light source (17) 222-3117 Brake Cleaner spray
If debris remains on wipes, use Brake Cleaner spray (17) and wipes to clean the spindle and wheel assembly. Inspect with a good light source (15). Refer to Illustration 33.
When wipe does not pick up any dirt or debris, the spindle and wheel assembly are clean.
Measure dimensional tolerances on the spindle. Refer to Guide, SEBF9238, "Fundamentals of Arc Spray for Reconditioning Components", Guide, SEBF9240, "Fundamentals of Flame Spray for Reconditioning Components", or Guide, SEBF9236, "Fundamentals of High Velocity Oxygen Fuel (HVOF) Spray for Reconditioning Components".
Cover the spindle and wheel assembly with a protective covering until ready for reassembly.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
After the front wheel group assembly has been completed, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8483, "Procedure for Kidney Looping Front Wheel Groups of 793 and 797 Off-Highway Trucks ". This procedure will reduce the contamination in the system to an acceptable ISO level. This activity must be done prior to returning the machine to service. Once in service, collect an S O S. analysis at 250 hours and count the particle of the oil. Contaminant levels will dictate when subsequent kidney loop filtering is required.