VALVE GP-CHECK 4372876 - Caterpillar

Accumulated grease and oil on a machine is a fire hazard.Remove debris with steam cleaning or high pressure water, at the specified interval in the Maintenance Interval Schedule or each time any significant quantity of oil is spilled on the machine.
For maximum service life of the machine, perform a thorough walk-around inspection before you mount the machine and before you start the engine.Daily, perform the procedures that are applicable to your machine.Reference: For more information, refer to Operation and Maintenance Manual, "Maintenance Interval Schedule".Remove any trash buildup and debris. Make all necessary repairs before you operate the machine.Note: Watch closely for leaks. If you observe a leak, find the source of the leak and correct the leak. If you suspect a leak or you observe a leak, check the fluid levels more frequently.Inspect the lights for broken bulbs and for broken lenses. Replace any broken bulbs and any broken lenses.Inspect the engine compartment for any trash buildup. Remove any trash buildup from the engine compartment.Inspect the cooling system for any leaks, for faulty hoses and for any trash buildup. Correct any leaks. Remove any trash from the radiator.Inspect all of the belts for the engine attachments. Replace any belts that are worn, frayed, or broken.Inspect the hydraulic system for leaks. Inspect the tank, the cylinder rod seals, the hoses, the tubes, the plugs, the connections, and the fittings. Correct any leaks in the hydraulic system.Inspect the final drives for leaks. Make any necessary repairs. Check the oil level if leakage is noticed.Inspect the swing drive for leaks. Make any necessary repairs.Make sure that all covers and guards are securely attached. Inspect the covers and the guards for damage.Inspect the steps, the walkways, and the handholds. Clean the steps, the walkways, and the handholds. Make any necessary repairs.Inspect the Falling Object Protective Structure for damage. If repair is necessary, consult your Caterpillar dealer. Tighten any loose bolts.Inspect the operator compartment for a buildup of trash. Check for a buildup of trash under the floorplate. Keep these areas clean.Adjust the mirrors for the correct rear view of the machine.