VALVE GP-CONTROL 4395453 - Caterpillar

Disconnect hose assembly (125) from governor assembly (124) .
Illustration 58 g00557161
Disconnect hose assembly (126) from governor assembly (124) .
Illustration 59 g00557166
Remove four bolts (128) and the hard washers. Remove filler (127) and the O-ring seal from torque converter (129) .
Illustration 60 g00586458
Disconnect two hoses (130) and (131) from the valve assemblies.
Illustration 61 g00737885
Disconnect hose (132) from the adapter.
Illustration 62 g00737886
Remove cotter pin (133) from slotted nut (134). Loosen slotted nut (134) that is on ball stud (135). Do not remove slotted nut (134) at this time.
Illustration 63 g00737942
Place Tool (B) under the ball stud and apply force. Hit the center arm with a soft faced hammer until the ball stud is loose. Remove Tool (B) from the ball stud. Remove the slotted nut from the ball stud.
Repeat Steps 67 and 68 for the other ball stud.
Use two people in order to remove the tie rod from the machine. The weight of the tie rod is 25 kg (55 lb). Repeat the procedure for the other tie rod.
Illustration 64 g00737889
Right Side
Remove two nuts (136), the bolts and the hard washers. Remove cap (137) from the mount assembly.
Illustration 65 g00737890
Left Side
Remove two full nuts (138), the bolts, and the hard washers. Remove the cap from mount assembly (139).
Illustration 66 g00737891
Remove four bolts (140), the nuts, and the washers from engine front support (141) .
Remove two bolts (142), the nuts, and the washers from engine support assembly (143) .
Illustration 67 g00831368
Illustration 68 g00737892
Illustration 69 g00831391
Illustration 70 g00737894
Attach Tool (C) to the engine, as shown. Attach Tool (D) to the rear, right side of the torque converter in order to prevent the engine from rotating. Secure Tool (C) and Tool (D) to a suitable hoist.
Carefully raise the engine and the torque converter. Be sure that all wire harnesses, hose assemblies and tube assemblies will not interfere with removal of the engine and the torque converter.
Remove engine support assembly (143) from the machine.
Check that there is proper clearance and remove the engine and the torque converter from the machine. Position the engine and torque converter on a suitable stand (not shown). The weight of the engine and torque converter is 2404 kg (5300 lb).