VALVE-FLOW DIVIDER 4505848 - Caterpillar

Audio alert - An external speaker that sounds when any remote switch is selected. A single tone is emitted with each selection. Two short tones alert you to any error messages. Three short tones indicate that the cutting edge of the machine has not moved to the correct elevation (grade and/or slope) within three seconds of going off grade.Display Icons
Elevation Display Icon
The elevation display icon indicates the type of elevation information that is shown on the Display. There are two elevation display icons.
The reference icon indicates that the information for the reference elevation is shown.
The cut/fill icon indicates that the cut/fill to grade is shown.
Illustration 2 g00993745
Elevation Display Icons (1) Reference Icon (2) Cut/Fill IconThe type of elevation that is shown on the Display depends on the Operating Mode that is configured. Refer to Operation and Maintenance Manual, "Operating Modes" for more information.Device Status Icons
Device status icons indicate the status of every device on the AccuGrade - Grade Control System. The following status icons can occur on the Display:Black Icons - Indicate detected devices.Missing Icons - Indicate Devices are not detected on power-up.Simulated Gray Icons - Indicate devices that were previoulsy detected, but have stopped communication while the Display was powered ON.Note: The AccuGrade - Grade Control System will not give grade guidance if any of the required devices are not detected.The following illustrations describe the device status icons for the AccuGrade - Grade Control System.
Illustration 3 g01041288
Device Status Icons (1) Device not connected at power-up or device is not supported by the configuration.
Illustration 4 g01128493
Sonic Tracer Icons (1) Sonic Tracer Connected (2) Sonic Tracer Not Connected
Illustration 5 g01128597
Device Status Icons (1) Slope Sensor Connected (2) Slope Sensor Not Connected
Illustration 6 g01128603
Device Status Icons (1) Rotation Sensor Connected (2) Rotation Sensor Not Connected
Illustration 7 g00993806
Device Status Icons (1) Auto/Manual Remote Switch Connected (2) Auto/Manual Remote Switch Not ConnectedHydraulics Available Icon
The "Hydraulics Available" icon indicates the status of the "Hydraulic Control System" for automatic operation. The display receives the hydraulic control status from the "Implement/Valve Control" ECM. Refer to Illustration 8."Auto Allowed" - The icon indicates the "Automatic Implement Control" is available and that the "Implement/Valve Control" ECM is able to recieve commands from the Grade Control.Auto Not Allowed (Icon Flashing) - The icon indicates the park brake is ON. The flashing icon also indicates a fault condition that has disabled the Automatic Implement control.Disconnected (Icon Grayed Out) - Iindicates that the "Implement/Valve Control" is no longer communicating with the "Display".Service Mode - The Park Brake is ON or a fault condition has disabled "Automatic Control".No Operator Detected - "Automatic Implement Control" was deactivated because the machine was in NEUTRAL gear for more than 60 seconds without operator input.
Illustration 8 g01309978