VALVE GP-PUMP CONTROL 4576556 - Caterpillar

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01212600
Illustration 2 g01212691
Install new guide springs (3) and (4) on valve lifters (6) and unit injector lifter (8) if the original guide spring was removed. Note: The guide springs must not be used again if the guide spring was removed from the valve lifter. If the guide spring was removed, install a new guide spring always.
Install inserts (2) while the end that is recessed is facing outward. Install new O-ring seals (1) in order to hold the inserts in place.
Immerse valve lifters (6) and unit injector lifter (8) in clean engine oil. Note: Compress guide springs (3) so that valve lifters (6) can be installed in guide (5).
Install valve lifters (6) in the original positions. Install the valve lifters so that the guide spring will be in the correct position.
Install unit injector lifter (8).
Install the valve lifters and the unit injector lifter to Dimension (X). Dimension (X) is 118 2 mm (4.6 0.1 inch). End By:
Install the valve lifter group. Refer to Disassembly and Assembly, "Valve Lifter - Install".