VALVE GP-BRAKE CONTROL 4637123 - Caterpillar

4637123 VALVE GP-BRAKE CONTROL Caterpillar parts

Price: query

Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4637123
463-7123
4637123

Caterpillar 4637123 VALVE GP-BRAKE CONTROL

Buy VALVE GP-BRAKE CONTROL 4637123 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 5

Caterpillar 4637123 Parts scheme VALVE GP-BRAKE CONTROL

For full view, you need register

Caterpillar SIS machinery equipment:

Caterpillar SIS

TH514C, TH417C, TH407C, TH414C, TH406C, TH337C, TH336C, Telehandler Transmission DJB00001-00483 (MACHINE) » 463-7123 VALVE GP-BRAKE CONTROL

TH414C Telehandler KEK00373-UP (MACHINE) » 463-7123 VALVE GP-BRAKE CONTROL

TH417C Telehandler RRJ00246-UP (MACHINE) » 463-7123 VALVE GP-BRAKE CONTROL

TH514C Telehandler KKW00177-UP (MACHINE) » 463-7123 VALVE GP-BRAKE CONTROL

Caterpillar parts catalog:

Caterpillar parts catalog
Product:

TH514C, TH417C, TH407C, TH414C, TH406C, TH337C, TH336C, Telehandler Transmission DJB00001-00483 (MACHINE)

463-7124: AXLE AR » SEBP69000175
463-7150: AXLE AR » SEBP69000176

TH414C Telehandler KEK00373-UP (MACHINE)

463-7150: AXLE AR » SEBP71680250

TH417C Telehandler RRJ00246-UP (MACHINE)

463-7124: AXLE AR » SEBP71690232

TH514C Telehandler KKW00177-UP (MACHINE)

463-7124: AXLE AR » SEBP71700237

Information:

Illustration 1 g01295974
Typical exampleNote: Bolts A and B are on the same end of the rod cap that has bearing tabs and location pin (1) .
Before assembly, put 6V-4876 Lubricant on the bolt threads and all surfaces that make contact between the bolt and the cap.
Tighten bolts A and B.Torque ... 90 5 N m (65 4 lb ft)
Tighten bolts C and D.Torque ... 90 5 N m (65 4 lb ft)
Tighten bolts C and D again.Torque ... 90 5 N m (65 4 lb ft)
Tighten each bolt again.Rotation ... 90 5 degrees
Illustration 2 g01293991
Typical exampleThe connecting rod must be measured in three places. Measure diameter (2). The diameter should be 143.028 0.015 mm (5.6310 0.0006 inch).Note: This procedure only applies to new connecting rods.Measure diameter (3) and diameter (4). Add diameter (3) and diameter (4) together. Divide the sum by two. This calculation must also be 143.028 0.015 mm (5.6310 0.0006 inch). If the measurements do not meet the specification, replace the connecting rod after verifying that the tightening procedure is correct.