VALVE GP-CONTROL 4790567 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 1P-1861 Retaining Ring Pliers 1
C 1P-1859 Retaining Ring Pliers 1
D 1P-1855 Retaining Ring Pliers 1
F 1P-0510 Driver Gp 1
G 135-7629 Seal Installer 1
H 452-6011 Grease -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01028588
Install seal (5) into housing (4).
Install washer (11) onto shaft assembly (10).
Use Tooling (G) to install seal (13) onto shaft assembly (10).
Use Tooling (F) to install seal (12) into housing (4). Lubricate seal (12) with Tooling (H).
Install washer (14) onto shaft assembly (10).
Use Tooling (D) to install retaining ring (7).
Raise the temperature of bearing (9) and spacer (8). Install bearing (9) and spacer (8) onto shaft assembly (10).
Raise the temperature of bearing (6). Install bearing (6).
Install shaft assembly (10) into housing (4).
Position housing (4) onto housing (15).
Install plate (17).
Use Tooling (B) to install retaining ring (16).
Install cam liner (18).
Install impeller (19).
Install cover (20).
Install spacer (3).
Use Tooling (C) to install retaining ring (2).
Install drive gear (1).End By:
Install the auxiliary water pump.