VALVE GP-CONTROL 4790596 - Caterpillar

4790596 VALVE GP-CONTROL Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4790596
479-0596
4790596

Weight: 16 pounds 7 kg.

Buy VALVE GP-CONTROL 4790596 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 3

Caterpillar 4790596 Parts scheme VALVE GP-CONTROL

For full view, you need register

Information:

Probable Causes
Battery cables and/or batteries
Starting motor solenoid or starting circuit
Starting motor and/or flywheel ring gear
Electrical power supply
Internal engine faultRecommended Repairs
Battery Cables and/or Batteries
Inspect the main power switch, battery posts, and battery cables for loose connections and corrosion. If the battery cables are corroded, remove the battery cables and clean the battery cables. Clean the battery posts. Replace the cables. Tighten any loose connections.
Inspect the batteries.
Charge the batteries.
Load-test the batteries. Refer to Systems Operation, Testing, and Adjusting, "Battery - Test".Starting Motor Solenoid or Starting Circuit
Test the operation of the starting motor solenoid. Refer to Systems Operation, Testing, and Adjusting, "Electric Starting System - Test".
Check the wiring to the starting motor solenoid.Starting Motor and/or Flywheel Ring Gear
Test the operation of the starting motor. Check the wiring for the starting motor. Refer to Systems Operation, Testing, and Adjusting, "Electric Starting System - Test".
Inspect the pinion on the starting motor and the flywheel ring gear for damage.Electrical Power Supply
If there is no electrical power supply, investigate the cause and rectify any defects. Refer to Systems Operation, Testing, and Adjusting, "Charging System - Test".Internal Engine Fault
Remove the glow plugs. Refer to Disassembly and Assembly, "Glow Plugs - Remove and Install".
Attempt to rotate the crankshaft through 360 degrees in both direction. If the crankshaft rotates correctly but fluid is expelled from the hole for the glow plug, investigate the cause of the fluid in the cylinder.
If the crankshaft rotates correctly and no fluid is expelled, install the glow plugs. Refer to Disassembly and Assembly, "Glow Plugs - Remove and Install".
If the engine does not rotate in Step 2, disassemble the engine. Refer to Disassembly and Assembly.
Inspect the internal components for the following conditions:
Seizure
Failure
Distortion
If the engine will still not crank, contact the technical communicator at a Caterpillar dealer.