VALVE & MOUNTING GP (NRS) 4795922 - Caterpillar

Status Group 4 - Engine Vision Interface Module (EVIM) Status
Illustration 4 g01266361
The "Engine Vision Interface Module" (EVIM) status parameter is used to confirm the port selection, baud rate, data size, and parity of the (EVIM) configuration.The "Engine Vision Display" must be configured to match the status information on this screen to allow proper communications between it and the PL1000T.Status Group 5 - Global Position System Information Module (GPSIM) Status
Illustration 5 g01266375
The "Global Position System Information Module" (GPSIM) status parameter is used to confirm the port selection, baud rate, data size, and parity of the GPSIM configuration. The GPS sensing module that is connected to this port must match the status information in this screen to allow proper communications between it and the PL1000T.The GPSIM screen also displays the "Vessel Speed" (knots), "Ground Speed" (MPH), "Directional Heading" (degrees), "Latitude" (degrees), and "Longitude" (degrees). The information can be viewed in order to confirm the communications between the GPS sensing module and the PL1000T.Status Group 6 - CCM Statistics
Illustration 6 g01266380
The "CCM Statistics" status screen is used to observe the number of messages that are being transmitted and that are being received, whether valid or invalid, by the PL1000T.A consistent increase in the number of invalid messages that are received, indicates there are communication problems between the PL1000T and the "Engine Vision Display". The port selection, baud rate, parity, and data size configurations for each of the modules should be checked. The configurations for each selection must match in order to enabled communications.Status Group 7 - EVIM Statistics
Illustration 7 g01266391
The "EVIM Statistics" status screen is used to observe the rate of messages that are being received by the PL1000T.A consistent increase in the number of invalid messages that are received, indicates there are communication problems between the PL1000T and the "Engine Vision Display". The port selection, baud rate, parity, and data size configurations for each of the modules should be checked. The configurations for each selection must match in order to enabled communications.Status Group 8 - GPSIM Statistics
Illustration 8 g01266402
The "GPSIM Statistics" status screen is used to observe the rate of messages being received by the PL1000T.The "Number of NMEA-183 messages Received" is the total count of the "NMEA-183" messages that were received on the configured serial port since the last time that power to the module was turned off then turned back on. When the message count reaches the maximum, the count will roll to zero and then will continue to increment. The count will reflect the total of all other message counts displayed on this status screen. If the counter is not incrementing, this can indicate communication problems between the PL1000T and the GPS sensing device. The configuration of both modules should be checked. The modules must match exactly for proper communications to be enabled.The "Number of NMEA-183 VTG messages Received" is the total count of the "NMEA-183 VTG" messages that were received on the configured serial port. The VTG messages contain the "Ground Speed" information. Use this message counter to confirm that the