VALVE 4834031 - Caterpillar

Illustration 6 g01710993
Table 3 describes the information that appears on the right side of the "Sky Plot" dialog.
Table 3
Data Field in the "Sky Plot" Dialog    
Field     Description    
"Time"     The time frame for the displayed satellite constellation information.    
"Actual SVs"     The number of satellites the system is using, based on the selected time frame.    
"Actual PDOP"     The PDOP of the solution.    
"Elevation mask"     The current elevation mask that is set in the GPS configuration.    
"GLONASS"     Enabled, if the system is using GLONASS satellites.    Sky Plot View
The left side of the "Sky Plot" dialog shows a plan view of the current satellite constellation. The section below describes the symbols that may appear in the satellite constellation.
A GPS satellite that the system is tracking and using in the position solution. The satellites identifier is displayed next to the satellites symbol.
A GPS satellite that the system is tracking but not using in the position solution. The satellites identifier is displayed next to the satellites symbol.
A satellite that is currently below the elevation mask. The satellites identifier is displayed next to the satellites symbol.
A GLONASS satellite that the system is tracking and using in the position solution. The satellites identifier is displayed, prefixed with an "R", next to the satelites symbol.
A GLONASS satellite that the system is tracking but not using in the position solution. The satellites identifier is displayed, prefixed with an "R", next to the satellites symbol.
A GLONASS satellite that is currently below the elevation mask. The satellites identifier is displayed, prefixed with an "R", next to the satelites symbol. The plan dialog also displays the following:
An inner circle, which represents the elevation mask
A "Psuedorandom" number (PRN). Numbers that are preceded by an "R" indicate GLONASS satellites. Numbers that are not proceeded by a "R" are GPS satellitesNote: The system does not use data from unsound satellites nor does the system display the position of the unsound satellites in the "Sky Plot" dialog.Editing the Sky Plot settings
Note: This feature is only available when using the MS990 receivers.The "Sky Plot - Edit Settings" dialog is used in order to accept or reject information from GLONASS satellites.Perform the following steps in order to edit the "Sky Plot" settings.
From the "Sky Plot" dialog, press the "Edit Settings" soft key. The "Sky Plot - Edit Settings" dialog will appear. Refer to Illustration 7.
Illustration 7 g01705262
Press the up or right arrow key in order to toggle "Yes" or press the left or down arrow key to toggle "No". If you wish to accept the GLONASS corrections, set the field to "Yes".
Press the "OK" key in order to accept the GLONASS corrections and return to the "Sky Plot" dialog. Press the escape key in order to cancel any changes and return to the "Sky Plot" dialog. The changes will take effect immediately.Display
The display can show several status messages that may