VALVE 4942019 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     236-1192     Lift Cylinder Brace As     1    Note: Make sure that all mounting surfaces are clean prior to installation.
Illustration 1 g00448784
Attach a suitable lifting sling to each side of the fixed axle, as shown. Attach a suitable hoist to both lifting slings. Raise the fixed axle into position. The weight of the fixed axle is 1540 kg (3400 lb).
Illustration 2 g00448802
Install the washers and four bolts (10) that hold the fixed axle to the front loader frame. The torque for bolts (10) is 1800 200 N m (1350 150 lb ft).
Illustration 3 g00448795
Install cover (9) and two bolts (8) on each side of the fixed axle.
Illustration 4 g00448763
Support front drive shaft (5) .
Slide yoke (4) into position on front drive shaft (5) .
Install four bolts (6) and two straps (7) on yoke (4) . The torque for bolts (6) is 170 15 N m (125 11 lb ft).
Connect grease tube (3) to the fixed axle.
Illustration 5 g00448685
Connect hose assemblies (2) to the fixed axle.
Connect tube assembly (1) to both sides of the fixed axle.
Fill the fixed axle. The capacity of the fixed axle is 65 L (17.2 US gal). Refer to Operation and Maintenance Manual, SEBU7035, " 966G Wheel Loader and 972G Wheel Loader" for the correct procedure.
Illustration 6 g03552019
Remove Tooling (A) and lower the bucket to the ground., End By:
Install the front drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Front) - Remove and Install"
Install the front tires and rims. Refer to Disassembly and Assembly, "Tire and Rim (Front) - Remove and Install".
Purge the air from the braking system. Refer to Testing and AdjustingRENR4387"966G II Wheel Loader and 972G II Wheel Loader Braking System" for the correct procedure.